GoPro HERO10 Black Action Camera User Guide
- June 5, 2024
- GoPro
Table of Contents
GoPro HERO10 Black Action Camera
Download the GoPro Quik App
Insert SD Card
LED Status
- Camera Power On: 3 blinks
- Camera Power Off: 7 blinks
- App/Remote Pairing: 1 blink per 1s
- QR Code Accepted: 2 blinks
- Idle Video Mode: 1 blink per 5s
- Idle Photo Mode: 2 blinks per 5s
- Idle Time Lapse Mode: 3 blinks per 5s
- Recording: 1 blink per 2s
- Stop Recording: 3 blinks
Connecting to Your Drone
Note: Please check polarity and wire configuration. Incorrect wiring can permanently damage camera.
Powering On
Note: The LED will blink 3x after powering on.
- Use the included mounting fingers to use your camera with GoPro mounts.
Pairing with the App
Aim your GoPro camera lens at the QR code to begin pairing with the GoPro Quik
app on your phone.
Note: The LED will blink 2x to confirm QR has been read.
Aim your GoPro camera lens at the QR code to set up your camera up with these settings:
- Video: 4K60 4:3
- Lens: Wide
- ISO: Max 1600
- HyperSmooth: Off
- Color: Flat
- EV Comp: -0.5
- Bit Rate: High
- Sharpness: Medium
Finishing Pairing with the GoPro Quik App
The GoPro Quik app is the easiest way to switch modes, adjust settings and
frame your shot.
Note: Your camera must be within 1 meter of your phone to pair with the
GoPro Quik app. Auto Upload is not supported by HERO10 Black Bones.
For more information and QR codes, go to gopro.com/bones
WARNING: HERO10 Black Bones is not waterproof.
For best performance, ensure there is enough airflow around your camera.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>