Danfoss 014G2420 Radiator Thermostat Ally User Guide
- June 4, 2024
- Danfoss
Table of Contents
Danfoss 014G2420 Radiator Thermostat Ally
Please use the manual provided with your gateway, and follow the instruction to download the App.
The
adapters from the right box side are included. Remaining adapters in the
overview above must be purchased separately. Adapter code numbers can be found
below each adapter illustration.
How to mount the thermostat. Remove the
battery cover as shown in the diagram and insert two AA batteries. Make sure
the batteries are correctly oriented. Screw the Danfoss Ally™ onto the mounted
adapter until a click sound appears. Press and hold the button for 3 seconds.
The temperature set point will show on the screen once the Danfoss Ally™ is
mounted.
How to reset the thermostat.
- Remove the cover and take out one battery.
- Press and hold , Keep holding while reinserting the battery. The screen will go blank after approximately 3 seconds.
Continue system setup in the App.
Safety precautions
SIMPLIFIED EU DECLARATION OF CONFORMITY
Hereby, Danfoss A/S declares that the radio equipment type Danfoss Ally™ is in
compliance with Directive 2014/53/EU. The full text of the EU declaration of
conformity is available at the following internet address:
www.danfoss.com The thermostat is not intended for
children and must not be used as a toy. Do not leave packaging materials where
children may be tempted to play with them, as this is extremely dangerous. Do
not attempt to dismantle the thermostat as it contains no user-serviceable
parts.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>