SOLAX POWER X3-MIC G2 Series Three-Phase String Inverter Installation Guide
- June 4, 2024
- SOLAX POWER
Table of Contents
SOLAX POWER X3-MIC G2 Series Three-Phase String Inverter
Packing List
Inverter Installation
PV Connection
AC Connection
WiFi Connection
- This inverter provides a WiFi/LAN port which can collect information from inverter including status, performance and updating information to monitoring website via connecting Pocket WiFi (Pocket LAN can be purchased from the supplier for optional if needed)
- Plug the Pocket WiFi (from Solax) into the port named “DONGLE” on inverter.
Note:
Please refer to the instruction manual for the appropriate usage of Pocket
WiFi.
Earth Connection and Overview
– Screw the ground screw with the allen wrench shown as follows. 
– Overview for connection. Start inverter:
- Turn on the external AC and DC connectors;
- Turn on the DC switch to the “ON“ position;
- Inverter will start automatically when PV panels generate enough energy, the LED will be blue.
USB Connection (for upgrading)
- Make sure the DC switch is off and the AC is disconnected with grid. Remove the Pocket WiFi module.
- Insert U-disk with upgrade package* into the DONGLE port on the bottom of the inverter. Then turn on DC switch and connect the PV connector, the LCD will show a picture as on the right.
- Press “Up” and “Down” to select ARM or DSP. Then long press “Down” and select the correct update file to confirm the update. After the upgrade is completed, please remember to turn off the DC switch or disconnect the PV connector, then pull off the U-disk, and connect the Pocket WiFi back.
- Please contact our service support to get the update package, and extract it into your U-disk. Do not modify the program file name! Or it may cause the inverter to stop working!
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>