Outwell 650605 Appetizer 1 Burner Stove Instruction Manual
- June 4, 2024
- Outwell
Table of Contents
APPETIZER 1-BURNER
MODEL: 650605 / 200-BT
APPETIZER 2-BURNER
MODEL: 650606 / 202-BT
INSTRUCTION MANUAL
Read these instructions for use carefully so as to familiarize yourself with the appliance before connecting it to its gas cartridge. Keep these instructions for future reference.
TECHNICAL DATA:
Appliance name:| Appetizer 1-Burner (650605 / 200-BT)| Appetizer
2-Burner (650606 / 202-BT)
---|---|---
Type of gas:| Butane-propane mixture
Category:| Direct pressure
Type of gas cartridge:| Both appliances should only be used with Primus
220693, 220794 or
220294 Butane-propane mixture gas cartridges in compliance with EN 417.
Injector size:| 0 0.28 mm| Ø 0.28 mm
Nominal rate in g/h and
in kW (Hs):| 3.0 kW (218 g/h)| 2 x 3.0 kW (218 g/h)
ASSEMBLY
- Pot or pan holder(s)
- Individually controlled burner knob(s)
- Inlet for connector/gas hose
- Gas hose
- Connector with female valve and female threaded
- Gas valve adaptor with tap
- Make sure that the appliance has been assembled correctly before using it.
- Slide the holder(s) (1) for the pot(s) or pan(s) into the small molded holes on the appliance.
- Take the gas hose (4) with the connector (5) and push the female valve gently, but firmly into the inlet (3) before screwing the female threaded collar tightly to the inlet.
OPERATION
-
CAUTION: Use outdoors only.
-
When in use the appliance should be placed in a location that is well-ventilated and protects it from direct draughts.
-
Accessible parts may be very hot.
-
Keep young children away from the appliance.
-
Do not misuse the appliance or use it for other purposes than what it is intended for.
-
Do not modify any parts of the appliance.
-
Do not try to repair the appliance. If you are not able to rectify any fault following these instructions, contact the dealer or Outwell Customer Service (contact details below).
-
Never leave the appliance unattended when lit.
-
Handle the appliance with care. Make sure not to drop it. Do not move the appliance during use.
-
Check that seals are in place and in good condition before connecting to the gas cartridge.
Do not use the appliance if a seal is damaged or worn. -
Do not use the appliance if it is leaking, damaged or does not operate properly.
-
The appliance shall be operated on a stable, horizontal and non-combustible surface.
-
The appliance shall be used away from flammable materials during use with minimum distances to adjacent surfaces (wall, ceiling) as shown below:
Connecting your appliance to a gas cartridge
To be able to use your appliance you will need to purchase a gas cartridge
which is suitable for this specific appliance. Please see TECHNICAL DATA table
for information regarding the gas cartridge.
- Position the gas cartridge at the side of your appliance, keeping in mind that the cartridge must be kept away from heat and in a safe and upright position.
- Make sure that the tap on the adaptor (6) is fully closed by turning it clockwise towards symbol “–“.
- Make sure that the individually controlled knob(s) (2) are closed by turning them fully clockwise towards the small “symbol “•”.
- Carefully screw the gas cartridge onto the adaptor (6) taking care not to cross thread. Screw down until the sealing washer meets the cartridge (hand-tight only).
- Always check for leaks at all joints before lighting the appliance.
- Never leave the adaptor (6) attached to the gas cartridge if the hose (4) with connector (5) is disconnected from the appliance.
Lighting Your Gas Appliance
- Make sure your gas appliance is assembled and gas cartridge connected according to above instructions.
- Open the tap on the adaptor (6) by screwing the tap counterclockwise towards the “+” symbol.
- Open the individually controlled burner knob(s) (2), depending on which burner you want to use, by screwing the knob(s) counterclockwise away from the small “•” symbol.
- Hold a lighter or match near the burner(s) to ignite.
- When the burner is lit, turn the control knob(s) (2) clockwise to decrease the heat intensity or extinguish, and counterclockwise to increase.
- Do not open valves beyond the point where maximum intensity is reached as this may cause unnecessary flaring and waste gas.
- Do not move the appliance or gas cartridge once lit as this may result in flaring. A warm-up period of about 1 minute is required to avoid flaring.
- If you experience flaring (high yellow flames), turn down the control knob (2) (towards the “•” symbol) until the flames are controlled and blue. Wait a few seconds and slowly increase the flame again.
- Avoid twisting of the flexible hose.
- If the gas pressure drops or the gas will not light, check if there is still gas left in the cartridge. If there is gas left in the cartridge the gas temperature may be too low.
For your safety – if you smell gas
- If there is a leak on your appliance (smell of gas), take it outside immediately into a well-ventilated flame-free location where the leak may be detected and stopped. If you wish to check for leaks on your appliance, do it outside. Do not try to detect leaks using a flame, use soapy water.
- If odour persists, contact the dealer or Outwell Customer Service (contact details below) and stop using the appliance immediately.
CHANGING OR DISCONNECTING GAS CARTRIDGE
- Only disconnect the gas cartridge when the appliance is not being used.
- The cartridge can be disconnected/reconnected even if some gas remains.
- Make sure to turn off the appliance completely by screwing the tap on the regulator (6) fully clockwise towards the symbol “-“ and the knob(s) fully clockwise towards the symbol “•”. Be careful the appliance could be hot.
- The gas cartridge shall be changed in a well-ventilated location, preferably outside, away from any sources of ignition, such as naked flames, pilots, electric fires, and away from other people.
- Carefully unscrew the gas cartridge from the adaptor (6).
- Check the contents of a cartridge by shaking it and listening for the sound of liquid gas.
- Dispose of as per instructions printed on the cartridge.
- To ensure a safe connection of a new gas cartridge to your appliance please read the sections ‘ASSEMBLY’ and ‘OPERATION’.
CLEANING & MAINTENANCE
- Visually check the general condition of the appliance and clean it on a regular basis.
- Ensure the appliance has cooled off completely before cleaning.
- Use a wire brush, steel wool or a scouring pad to clean the pot/pan holder(s)(1).
- Interior surfaces of the appliance housing cover should also be washed with hot soapy water.
- Check the burner(s) regularly to see that it is free from insects and spiders which may block the gas system.
- Check the seals regularly to ensure that they are in good condition. If there is any sign of wear and tear the seals must be replaced with new ones. Contact the dealer or Outwell Customer Service (contact details below).
- Check and clean the injectors on the appliance if they are blocked.
CLEANING THE INJECTORS:
-
Fully turn off the control knob(s) (2) and disconnect the gas cylinder
-
Remove the pot/pan holders (1)
-
Turn the appliance upside down and loosen the base of the burner
-
Blow compressed air through the hole to clean the injector
-
Reassemble the base of the burner
-
Place the pot/pan holder(s) (1) back into the molded holes.
-
Reconnect the gas cylinder. Check the connecting joint with warm soapy water.
HOW TO CHECK FOR LEAKS WITH SOAPY WATER
- Take a soft cloth and wring it up in soapy water.
- Apply a small amount of the soapy water mixture to all joints of gaseous parts.
- If there is a leak, you will be able to see it as bubbles in the soapy water.
- If you detect a leak stop using the appliance immediately and contact the dealer or Outwell Customer service (contact details below).
STORAGE
- Ensure the appliance has completely cooled down.
- Disconnect the gas cartridge before you store the appliance away.
- Keep both the appliance and cartridge in a dry and well-ventilated place, safe from dust and dirt, and away from heat and direct sunlight.
Outwell Customer Service
e-mail: info@outwell.com
Tel.: +45 70 22 85 00
outwell.com
Outwell® is a reg. trademark of Oase Outdoors EU: Kornvej 9, DK-7323 Give,
Denmark
UK: One Glass Wharf, Bristol, BS2 0ZX
Outwell® is a reg. trademark of Oase Outdoors
EU: Kornvej 9, DK-7323 Give, Denmark
UK: One Glass Wharf, Bristol, BS2 0ZX
P.I.N. 2531/CS/0063
© 12/2021 Oase Outdoors ApS. Made in China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>