Outwell SB-6071 Solar Lantern Instruction Manual
- May 15, 2024
- Outwell
Table of Contents
Outwell SB-6071 Solar Lantern Instruction Manual
INSTRUCTION MANUAL
Light modes:
- Press the button (7.) to switch on the light.
- Press and hold the button to dim the light. The light can be dimmed step-less to any setting between maximum and minimum light output. When lowest or highest setting is reached, the lamp will stay at that setting.
- Press and hold once more to dim again
- Press the button to switch off the light.
Use of the lamp:
- Lamp is charged using 5V DC USB power outlet. Micro USB input is located under protective lid (3.)
- Charging cable is included with the lamp. Charge time from empty to full app. 2 hrs. Lamp can also be charged from the built-in solar panel. Charge time from empty to full app. 16 hrs
- Lamp have built-in overcharge protection circuit.
- When charging the charging indicator (4.) lights red. When fully charged the indicator lights green.
- Please fully charge the lamp before use
- Lamp can be used as a torch when fully collapsed, or as a lantern when extended
- To extend lantern lampshade, grab the upper and lower parts of the lamp -> twist them counter clockwise from each other until casing opens -> gently pull apart until lampshade is fully extended
- To collapse the lampshade, reverse the above.
- Lamp can also be used as power bank to charge phones etc. USB output is located under protective lid (3.)
- Lamp can be used standing, hanging from the hanger (2.)
- Lamp is water resistant to IP44
- Lamp can be cleaned with water or a damp rag. Do not use corrosive liquids to clean the lamp
- Do not stare into the light source
Light source: 1W LED
Light source and control gear is not replaceable. This would introduce weak
points in the construction, that could reduce the lifetime of the product.
Instruction for removal of light source and control gear by market surveillance authorities:
- Remove lamp shade by hand.
- Remove 4 pcs plugs covering the screw holes using a pick.
- Unscrew 3 pcs screws (the fourth hole have no screw).
- Unscrew 2 pcs screws under the hanger and take apart the lamp.
- Unscrew 3 pcs screws holding lamp shade backplate in place.
- Unscrew screws holding light source in place.
- Cut needed wires to remove the required components for testing.
Instruction for disassembly of lamp for disposal of components when lamp has reached the end of its usable life:
– See steps 1-6 above
7) Cut wires to allow removal of battery. Dispose of battery according to
local regulations.
8) Cut wires and remove screws to allow removal of electronics on circuit
board. Dispose of electronics according to local regulations.
9) Dispose of remaining components according to local regulations.
Technical data:
nput USB: 3.7V , 400mA
Input Solar: 5V , 50mA
Output: 5V , 400mA
Battery: 3.7V , 800mAh Li-Po
Class 3 appliance
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>