nuna NST15705 TRVL Compact Stroller Instruction Manual
- June 4, 2024
- nuna
Table of Contents
nuna NST15705 TRVL Compact Stroller
SAFETY WARNING
Failure to follow these warnings and instructions could result in serious injury or death.
- A child’s safety is your responsibility. NEVER leave your child unattended.
- To avoid any danger of suffocation, remove all plastic covers before using the stroller and destroy or keep away from babies and children!
- Keep small parts away from children as they pose a choking hazard.
- Discontinue using this stroller if it becomes damaged or broken.
- Use original Nuna parts and accessories only.
- Use of this stroller with a child weighing more than 50 lb (22.7 kg) or taller than 45 in. (114.3 cm) in height will cause excessive wear, and stress on the stroller, and could create an unstable condition.
- Use the stroller with only one child at a time.
- To prevent a hazardous, unstable condition, do not place more than 10 lb (4.5 kg) in the storage basket before use.
- Negotiate curbs and rough ground carefully. Repeated impact could cause damage to this stroller.This stroller is to be used only at walking speed and is not intended for use while jogging, skating, etc.
- The parking brake MUST be engaged when the stroller is stopped and when placing and removing child.
- Overloading, incorrect folding, and using accessories other than those approved by Nuna, e.g. child seats, bag hooks, rain covers, buggy boards, etc., may damage or make this stroller unsafe.
- Adding accessories such as purses, shopping bags, or parcels to the handle or canopy can cause the stroller to be unstable.
- This stroller does not replace a crib or a bed. Should your child need to sleep, they should be placed in a crib or approved sleeping area based on your child’s requirements.
- Avoid serious injury from falling or sliding out. Always use seat belt. After fastening buckles, adjust belts to get a snug fit around your child.
- This stroller has been designed to use from birth. We recommend using lowest reclined position for newborn babies.
- Child may slip into leg openings and strangle.
- Avoid finger entrapment Use care when folding and unfolding the stroller. Be certain the stroller is fully erected and latched before allowing your child near the stroller
- Strangulation Hazard Do not place items with a string around your child’s neck, suspend strings from the stroller, or attach strings to toys.
- ALWAYS keep your child in view while in this stroller.
- ALWAYS allow the fabric to dry naturally away from direct heat.
- ALWAYS check that the attachments are correctly engaged.
- DO NOT let your child play with this stroller.
- DO NOT place any item on the canopy of this stroller.
- DO NOT leave this stroller exposed in the vicinity of a strong source of heat i.e. a radiator or open fire or store this stroller in a damp place.
- DO NOT make any changes or modifications to this stroller that are not specified in this manual.
- DO NOT use storage basket as a child carrier.
- NEVER use the stroller on stairs or escalators. You may suddenly lose control of the stroller or your child may fall out.
- NEVER allow your child to stand on the footrest.
Parts List
Make sure all parts are available before assembly.
If any part is missing, please contact Nuna. No tools are required for
assembly.
-
Stroller Frame
-
Armbar
-
Front Wheel (x2)
-
Rear Wheel (x2)
-
Canopy
-
Calf Support
-
Footrest
-
Front Swivel Lock
-
Front Wheel Release
Button -
Calf Support Adjustment
Button -
Buckle
-
Shoulder Harness Pad
-
Infant Carrier Lock
-
Secondary Lock
-
Handle
-
One-Hand-Fold Button
-
Recline Adjustment
Handle -
Recline Adjustment
Straps -
Storage Basket
-
Rear Wheel Release
Button -
Rear Brake Lever
-
Canopy Window
-
Carry Bag
Product Setup
Open Stroller
-
Take the stroller frame out.
-
Rotate the stroller handle up.
-
Open the stroller fra me.
-
A “click” sound means the stroller frame is open completely.
Check that the stroller is completely latched open before continuing.
Storage Basket -
Hook the storage basket on the rear legs on both sides.
Rear Wheels
-
Insert the rear wheels into the rear legs.
-
A “click” sound means the rear wheel is assembled completely.
Check that the wheels are securely attached by pulling on them. -
To remove the rear wheel, press the release button (1) and detach the rear wheel from the rear leg (2).
Front Wheels -
Insert the front wheels into the front legs. A “click” sound means the wheel is assembled completely. Check that the wheels are securely attached by pulling out.
-
To remove the front wheel, press the release button (1) and then detach the front wheel from the front leg (2).
Canopy
-
Slide the canopy mounts onto the stroller.
-
A “click” sound means the canopy is assembled completely.
-
Snap the buttons on the back panel of canopy to the backrest.
Armbar
It is always recommended that the armbar be used, but it is not a restraint device. Always secure the child with the harness. -
Align the armbar ends with the armbar mounts, and insert until it clicks into place. A “click” sound means the armbar is assembled completely.
-
To rotate the armbar, press the armbar release button on one side (1) and rotate the armbar from the other side (2).
-
To remove the armbar, press the armbar release buttons (1) and pull the armbar out (2).
Check Setup
- Stroller frame is latched open
- Rear and front wheels are securely attached
- Armbar is securely attached
Product Use
Securing Your Child
The parking brake MUST be engaged when the stroller is stopped and when
placing and removing child.
To avoid serious injury from falling or sliding out, always secure your child
with the harness.
Make sure the harness is adjusted properly and your child is snugly secured.
The space between the child and the shoulder harness should be about the
thickness of one finger. DO NOT cross the shoulder belts. This will cause
pressure on your child’s neck.
-
Push the top button on the buckle (1) to release the buckle latch and remove the magnetic clips (2). Place your child in the stroller.
-
Insert the waist clips into the center buckle (1). Slide the crotch belt adjustment buckle to adjust as needed (2).
-
Open the harness covers to adjust the harness.
-
Fit the harness snugly to your child by sliding the adjustment straps to tighten.
Shoulder Harness Position -
The upper shoulder harness buckles can be moved up and down for added adjustment.
Can opy 1
-
To open the canopy, pull the canopy toward the front of
the seat, and to close the canopy, push it back. -
For added ventilation, flip the canopy window cover up.
-
Unzip the canopy rear panel to open.
-
To open the back of the canopy completely, undo the four snaps (1), roll up the fabric (2), thread the strap through the loop at the top of the canopy and fasten the snap to secure (3).
Recline -
To raise the recline, pull the recline adjustment straps and push the seat up.
-
To recline the backrest, squeeze the recline adjustment handle and pull the backrest down.
Shoulder Harness Pads 1
- To put on the harness pads, slide the pad under the shoulder harness strap, keeping the opening in the pad around the shoulder harness buckle.
- Slide the tab on the harness pad through the shoulder harness buckle.
- Fold the harness pad and fasten the snaps.
Calf Support The calf support has 2 positions.
-
To raise the calf support, lift up. To lower the calf support, press the adjustment buttons on the underside of the calf support (1) and push down (2).
Brake -
To lock the rear wheels, step down on the brake lever.
-
To unlock the rear wheels, step down on the brake lever again.
Always apply the brake when the stroller is stopped.
Push the stroller slightly to ensure the brake is engaged.
Front Swivel Locks
It is recommended to use the front swivel locks on uneven surfaces. -
Turn the front swivel lock to lock the front wheel.
-
Turn the front swivel lock back to unlock it.
Fold 1
Ensure that the front swivel locks are unlocked before folding the stroller.
- Ensure that the snap on each side is fastened correctly before folding the stroller.
- Fold the canopy.
- Slide the lock against the handle (1) and then squeeze the folding button (2).
- Fold the top of the stroller down.
- The frame can fold and stand on its own.
Accessories 1
Carry Bag
-
Put the folded stroller into the carry bag and close the bag using the drawstring.
PIPA™ Series Infant Carrier -
Recline the stroller seat to the lowest position. Push the canopy to the rear of the stroller and attach the arm bar.
-
Release the infant carrier lock.
-
Place the infant carrier on the stroller so it sits over the arm bar.
-
Close the infant carrier lock to secure the infant carrier on the stroller. Pull up on the infant carrier to check that it is fully locked to the stroller.Remove the infant carrier before folding the stroller.
-
To remove the infant carrier, release the infant carrier lock, squeeze the release handle (1), and lift the infant carrier up (2).
Cleaning and Maintenance
- Clean the frame, plastic parts, and fabric with a damp cloth, but do not use abrasives or bleach.
- Do not use silicon lubricants as they will attract dirt and grime. Do not store your stroller in a damp place.
- Clean the stroller wheels regularly with water and remove any dirt.
- To ensure long-lasting use, wipe off this product with a soft, absorbent cloth after using it in rainy weather.
- Refer to the care label attached to the fabric for washing and drying instructions.
- It is normal for fabric to color from sunlight and to show wear and tear after a long period of use, even when used normally.
- For reasons of safety, only use original Nuna parts.
- Check regularly if everything functions properly. If any parts are torn, broken, or missing, stop using this product.
Warranty
We have purposely designed our high-quality products so that they can grow
with both your child and your family. Because we stand by our product, our
gear is covered by
a custom warranty per product, starting from the day it was purchased. Please
have the proof of purchase, model number and manufactured in date available
when you contact us.
For warranty information please visit:
www.nunababy.ca
Contact
For replacement parts, service, or additional warranty questions, please
contact our customer service department.
In Canada:
[email protected]
1.800.667.4111