Nuna TRVL Collapsing Lightweight Stroller User Manual

Nuna TRVL Collapsing Lightweight Stroller

WARNING

Failure to follow these warnings and instructions could result in serious injury or death.
Always use the restraint system.
Check that the pram body or seat unit or car seat attachment devices are correctly engaged before use.
Do not let the child play with this product.
Ensure that all the locking devices are engaged before use.
Never leave the child unattended.
This product is not suitable for running or skating.
To avoid injury ensure that the child is kept away when unfolding and folding this product.
Accessories which are not approved by the manufacturer shall not be used. Only replacement parts supplied or recommended by the manufacturer/distributor shall be used.
Adult assembly required.
ALWAYS set the parking brake when you stop.
Any damage caused by the use of accessories not supplied by Nuna will not be covered in terms of warranty.
Any load attached to the handle and/or on the back of the backrest and/or on the sides of the vehicle will affect the stability of the vehicle.
Be certain the stroller is fully erected and latched before allowing your child near the stroller.

• DO NOT carry additional children, goods, accessories in or on the stroller except as permitted in this manual. They may cause the stroller to become unstable.
• DO NOT leave the stroller exposed in the vicinity of a strong source of heat i.e. a radiator or open fire.
• DO NOT place any item on the canopy.
• DO NOT store the stroller in a damp place. Always allow the fabric to dry naturally away from direct heat.
• DO NOT use storage basket as a child carrier.
• DO NOT use the stroller if any parts are damaged or missing.

For car seats used in conjunction with a chassis, this vehicle does not replace a cot or a bed. Should your child need to sleep, then it should be placed in a suitable pram body, cot or bed. Keep small parts away from children as they pose a choking hazard. Negotiate curbs and rough ground carefully. Repeated impact could cause damage to the stroller.

• NEVER allow children to stand on the stroller.
• NEVER carry more than one child at a time in the stroller.
• NEVER use the stroller on stairs or escalators. You may suddenly lose control of the stroller or your child may fall out.

The harness must always be correctly fitted and adjusted. The harness is not a substitute for proper adult supervision. The parking break shall be engaged when placing and removing children. Overloading, incorrect folding, and the use of accessories e.g. child seats, bag hooks, rain covers, buggy boards, etc… other than those approved by Nuna may damage or make the stroller unsafe. Rubber tires may leave black scuff marks on smooth surfaces such as parquet, laminate and linoleum. STRANGULATION HAZARD Do not place items with a string around your child’s neck, suspend strings from this product, or attach strings to toys. To avoid any danger of suffocation, remove all plastic covers before using this item and destroy or keep away from babies and children! To prevent a hazardous, unstable condition, do not place more than 4.5 kg in the storage basket. USE the most reclined position for new born babies. Use the stroller with a child weighing no more than 22 kg. It will cause damage to the stroller with an unfitted child. TRVL instructions

Parts List

Make sure all parts are available before assembly.
If any part is missing, please contact local retailer. No tools are required for assembly.

CHOKING HAZARD: Remove and immediately discard protective end caps from each wheel and wheel hub axle.

1. Stroller Frame
2. Armbar
3. Front Wheel (x2)
4. Rear Wheel (x2)
5. Canopy
6. Calf Support
7. Calf Support Adjustment Button
8. Buckle
9. Shoulder Harness Pads
10. Infant Carrier Lock
11. Secondary Lock
12. Handle
13. One-Hand-Fold Button
14. Recline Adjustment Handle
15. Storage Basket
16. Rear Brake Lever
17. Canopy Window
18. Carrying strap

Product Set Up

Open Stroller

1. Take the stroller frame out (1).
2. Rotate the stroller handle up (2) and open the stroller frame (3)(4). A “click” sound means the stroller frame is open completely. Check that the stroller is completely latched open before continuing.

Basket
Hook the basket on the rear legs on the both sides. (5)
Rear Wheels

1. Insert the rear wheel into the rear leg. A “click” sound means the rear wheel is assembled completely. Check that the wheels are securely attached by pulling on them.
2. To remove the rear wheel, press the release button (7)-1 and detach the rear wheel from the rear leg (7)-2.

Front Wheels

1. Insert the front wheel into the front leg. A “click” sound means the wheel is assembled completely. Check that the wheels are securely attached by pulling on them.
2. To remove the front wheel, press the release button (9)-1 and then detach the front wheel from the front leg (9)-2.

Canopy
Slide the canopy mounts onto the stroller (10). A “click” sound means the canopy is assembled completely.

Armbar

1. Align the armbar ends with the armbar mounts, and insert until it clicks into place (11). A “click” sound means the armbar is assembled completely.
2. Press armbar release button (12)-1, and then pull up the armbar (12)-2. Always secure the child with the harness. The armbar is not a restraint device. Armbar can be open for easy seating and unseating of child.

Product Use

Securing Your Child

• The parking brake MUST be engaged when the stroller is stopped and when placing and removing child.
• To avoid serious injury from falling or sliding out, always use the seat belt.

Make sure the harness is adjusted properly and your child is snugly secured. The space between the child and the shoulder harness should be about the thickness of one finger. DO NOT cross the shoulder belts. This will cause pressure on your child’s neck.

1. Push the top button (13)-1, the buckle will release automatically.
2. Match the waist belt buckle with the shoulder buckle, and align them with the center buckle, the buckle can lock automatically. (14)
3. Fit the harness snugly to your child by sliding the adjustment straps to tighten (15)-1. Then pull the waist adjustment straps out (15)-2

Shoulder Harness Position

1. Thread the fixing webbing on the Shoulder harness pads through the hole of buckle. (16)(17)
2. The upper shoulder harness buckles can be moved up and down for added adjustment. (18)

Canopy
For added air flow, unzip the back zipper to expose the mesh. (19)

Calf Support
The calf support has 2 positions.

1. To raise the calf support, lift up.
2. To lower the calf support, press the adjustment button in the middle of the calf support (20)-1, and push down (20)-2.

Recline

1. To raise the recline, pull the tether and push the seat up. (21)
2.  To recline the backrest, squeeze the backrest adjustment handle and pull the backrest down Make sure the recline is adjusted properly for use.

Brake

1. To lock the rear wheels, step down on the brake lever. (23)
2. To unlock the rear wheels, step down the brake lever again. (24)

Always apply the brake when the stroller is stopped. Push the stroller slightly to ensure the brake is engaged.

Front Swivel Locks

1. It is recommended to use the front swivel locks on uneven surfaces.
2. Turn the front swivel lock to lock the front wheel (25). Turn back to unlock (26).

Fold

1. Fold the canopy. (27)
2. Slide the secondary lock and then squeeze the folding button (28).
3. While squeezing the folding button, fold the handle down, the stroller will fold and stand on its own. (29)-(31)
4. You can carry the stroller with the strap. (32)

Accessories

Not all accessories are included on some models.

PIPA Series Infant Child Restraint
For infant carrier assembly and usage, please refer to the infant carrier instruction manual. Recline the stroller seat to the lowest position, push the canopy to the rear of the stroller and attach the arm bar.

1. To open the infant carrier lock, slide the latch out (33)-1. To close the infant carrier lock, slide the latch in (33)-2.
2. Place the infant carrier on the stroller so it sits over the arm bar (34). Then close the infant carrier lock. (33)-2 Pull up on the infant carrier to check that it is fully locked to the stroller. Remove the infant carrier before folding.
3. To remove the infant carrier, open the infant carrier lock (33)-1, squeeze the release handle (35)-1 and lift the infant carrier up (35)-2.

Cleaning and Maintenance

Clean the frame, plastic parts, and fabric with a damp cloth, but do not use abrasives or bleach. Do not use silicon lubricants as they will attract dirt and grime. Do not store your stroller in a damp place. Clean the stroller wheels regularly with water and remove any dirt. To ensure long-lasting use, wipe off this product with a soft, absorbent cloth after using it in rainy weather. Refer to the care label attached to the fabric for washing and drying instructions. It is normal for fabric to color from sunlight and to show wear and tear after a long period of use, even when used normally. For reasons of safety, only use original Nuna parts. Check regularly if everything functions properly. If any parts are torn, broken, or missing, stop using this product.

References

• Nuna | Functional Car Seats, Premium Strollers & Baby Gear
• Nuna | Premium Car Seats, Pushchairs, and Baby Gear PL

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>