Speco Technologies O4VB1 Outdoor Network Bullet Camera User Guide
- June 4, 2024
- speco technologies
Table of Contents
Speco Technologies O4VB1 Outdoor Network Bullet Camera
Warning and Caution
If the product does not work properly, please contact your dealer or the nearest service center. Never attempt to disassemble the camera yourself. Any unauthorized changes or modifications could void the warranty. Do not allow water or liquid intrusion into the camera. All installation and operation here should conform to local electrical safety codes. Make sure the device is firmly installed on the wall or ceiling. Do not use camera beyond specified voltage range. Do not drop the camera or subject it to physical shock. Avoid touching the camera lens. If cleaning is necessary, please use cleaning cloth to wipe it gently. Do not aim the camera at the sun or extremely bright light sources. Do not place the camera in extremely hot or cold environments and dusty and damp locations. Do not expose it to highly electromagnetic radiation. Do not block any ventilations.
Package
Overview
1
| Fixed ring|
4
| DC power connector
---|---|---|---
2
| Mounting base|
5
| Micro SD card slot
3
| Ethernet connector|
6
| Reset
* 1 It is recommended to install the security cap for outdoor
installations.*
2 DC 12V power supply is not required if a PoE switch or injector is used
to power the camera.**
Connecting Network Cable
① Loosen the nut from the main element.
② Run the network cable (without RJ 45 connector) through both elements. Then
crimp the cable with RJ 45 connector.
③ Connect the cable to the hermetic connector. Then tighten the nut and the
main cover.
Installation
- Before you start, please make sure that the wall or ceiling is strong enough to withstand three times the weight of the camera.
① Open the mounting base and the upper cover of the junction box.
② Install junction box onto the wall by using the screws provided.
② Install junction box onto the wall by using the screws provided.
④ Connect the cables and then install the camera onto the junction box as
shown below.
⑤ Bracket Adjustment-Loosen the fixed ring to adjust the view angle of the
camera. After you get the optimum angle of view, tighten the fixed ring to
complete the installation.
Web Operation and Login
IP Scanner can search for the device on the local network.
Operation
① Make sure thatthe camera and thePC are connected to the same local network.
The camera is setto DHCPby default.
② Install IP Scanner from the CD and run it after installation.
③ In the device list, you can view the IP address, model number, and
MAC address of each device. Select the applicable device and double click to
open up the web viewer. You can also manually enter the IP address in the
address bar of the web browser.
The login interface is shown above. Default user name is admin and password is
1234. After logging in, follow directions to install applicable plugins.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>