WENTELMICRO T9 2BEJ8-T9 Wireless System of Guitar Transmitter and Receiver Instruction Manual

WENTELMICRO T9 2BEJ8-T9 Wireless System of Guitar Transmitter and

Receiver Instruction Manual

Charging

Computer, Charge pal or mobile phone Charger.

Quality assurance

This product is manufactured by strict quality control and inspection
Ifit shows any defects within the guaranteeperiod, pleasecontact with customer support center for repairmen in free.
If it shows any defects outside the guarantee period or under unusual usage, please contact with customer support center for maintenance with cost
If repair it, please present the quality guarantee card of this product.
Guarantee letter can not be re-issued again, so please keep it carefully.
This guarantee is available only in the domestic.

Specification

Product warranty

Product name| Wireless System of Guitar Transmitter and Receiver| Model| ****

T9 5.8 GHz TX/RX

---|---|---|---

Purchase date

| ****

Year Month Day

| ****

Guarantee period

| ****

One year

| Holding period for repairing part| One year after the

purchase date

Customer

| Name|  | Phone|
Address|

Manufacturer

| Name|  | Phone|
Address|

Retailer

| Company name|  |

Phone

|
Address|  | Contact person|

User’s Manual

1

Power switch

| ON

up OFF and down ON

---|---
2

Bind button switch/volume ±

|   Long press the button for 3 seconds to start binding, and it will end automatically when completing successfully. Short press it to enter the volume cycle for 0.3.6.9 in turn
3

Charging

| by plugging in the TPYE–C USB cable
4

Signal input plug

| One-to-two adapter plug, rotate type 6.5 plug to the right to open the 3.5, in order to connect to electro- acoustic instruments like guitars
5

Signal input plug

| One-in-two adapter plug, rotate type 6.5 plug to the right to open the 3.5, in order to connect speakers, adapter cables and other audio equipment
6

Connection status sign

| It lights up to show successful pairing between TX and RX
7

Battery sign

| To display battery condition
8

Volume status sign

|

Real-time display of its input, output and changes

9

Volume sign

| +0、+3、+6、+9

There is a total of four gears +0, +3, +6, +9

Sketch of connecting with voice box

Connecting Mode

• T9
• Shall inset the T9 transmitter plug into the output socket of audio
• T9
• Shall inset the T9 receiver plug into the input socket of voice box

Sketch of recording connection

• By the patch cord, you can send the signal obtained by receiver to the computer, table pc or cellphone
• You can equip right patch cord according to your own equipment type
• By this way, you can record the voice made from instrument or share it on the internet

FCC Warnning:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection againstharmful interference in a residential installation. This equipment generates, uses and can radiateradio frequency energy and, if not installed and used in accordance with the instructions, maycause harmful interference to radio communications. However, there is no guarantee   thatinterference will not occur in a particular installation. If this equipment does cause harmfulinterference to radio or television reception, which can be determined by turning the equipmentoff and on, the user is encouraged to try to correct the interference by one or more of thefollowing measures:

• Reorient or relocate the receiving
• Increase the separation between the equipment and
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
• Consult the dealer or an experienced radio/TV technician for

Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 0cm between the radiator and your body.

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>