FIRSTECH REL300-1WFX Keyless Entry System User Guide
- June 6, 2024
- FIRSTECH
Table of Contents
QUICK START CARD
8102REUCL000100
FT-1 B Guide REVl
1 WAY 1 BUTTON REMOTES
| Tap this button for l second to lock your doors and/or arm your vehicle.
Tap this button twice within l second to unlock your doors and/or disarm your vehicle.
Hold this button for 3 seconds to start your vehicle. Your vehicle’s parking lights will flash once and/or siren will chirp once tor confirmation. repeat and your vehicle will shut off.
---|---
Valet Mode: If your remote start is not working, you may be in Valet Mode. Your parking lights will also not flash. Your doors will still lock and unlock. To exit Valet Mode, turn the vehicle’s ignition On and then top this button 5 times, waiting a second between each top. Your vehicle will flash the parking lights twice and exit Valet Mode. You can also exit Valet Mode by turning the ignition On and then topping the foot broke l O times or reprogramming your remote(s).
ALARM LED CODES
If you have an alarm and optional LED(s) installed, it will flash once a second if armed. If your alarm is triggered then the LED(s) will flash more than once until it is disarmed. See the table below for what each LED code represents.
ALARM TRIGGER EVENT | LED FLASHES |
---|---|
Door, Hood, Trunk, or lgni!ion On triggered | 2, Pause, Then Repeat |
Full triggered shock sensor | 3, Pause, Then Repeat |
Optional sensor 1riggered | 4, Pause, Then Repeat |
Panic Mode | 5, Pause, Then Repeat |
To reprogram your remote first cycle the key in the ignition 5 times within 7 seconds. Parking lights will flash. After that tap the Lock button on your remote. Repeat for any additional remotes. If you receive two parking light flashes, your system has exited remote programming mode and you must retry.
Register online at www.compustar.com within l 0 days of purchase to activate your new remote’s warranty.
START ERROR CODES
PARKING LIGHT FLASHES | REMOTE START ERROR |
---|---|
3 then l | l: Motor running |
3 then 2 | 2: Key in ignition on position |
3 then 3 | 3: Door open (manual transmission only) |
3 then 4 | 4: Trunk open |
3 then 5 | 5: Foot broke on |
3 then 6 | 6: Hood open |
3 then 7 | 7: Reservation off (manual transmission only) |
3 then 8 | 8: loch or voltage sensing failure |
3 then 9 | 9: FT.DAS sensor shutdown |
3 then l 0 | l 0: System is in Vole! Mode |
Questions/comments? Contact us at 888-820-3690 from 8 AM to 5 PM PST. Also please visit www.compustar.com for a complete user’s manual.
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this device.
IC
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may
cause undesired operation of the device.
8102REUCL000100
FT-1 B Guide REVl
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>