OUTWELL 650773 / HT-415 WIND PUMP USB Instruction Manual
- June 4, 2024
- Outwell
Table of Contents
OUTWELL 650773 / HT-415 WIND PUMP USB Instruction Manual
WIND PUMP USB
Read this manual before using the product.
Keep the manual for future reference.
- Pump unit
- On/off switch
- 12V charge socket
- Inflation/deflation nozzles
- USB charger with DC plug and cord
- Deflation port
- Inflation port
WARNINGS
-
The pump must only be used by with the USB charger supplied with the pump.
-
This pump is intended to inflate items such as air mattresses, inflatable furniture etc. It is not designed for continuous use exceeding 10 minutes. Extended operation can overheat and damage the pump.
-
Do not exceed 10 minutes of continuous operation.
Take a 20-minute break before resuming inflation. -
Carefully follow the instructions on the item you are inflating.
Never exceed the recommended pressures. Bursting items can cause serious injury. -
Never leave the air pump unattended while in use.
-
CAUTION: To reduce the risk of electric shock, do not expose the air pump to rain and store it indoors. Do not use the air pump under wet conditions. Do not drop pump into water or other liquids. Do not operate the pump with wet hands.
-
Never allow sand, small rocks, etc. to be sucked into the inflation or deflation port while in use.
-
Never look into or point the inflate opening toward your eyes while pump is operating.
-
Never place your hand or fingers into the inflation or deflation opening at any time.
-
Never attempt to disassemble or close to the openings while the air pump is operating.
-
The supply cord, on the power supply, cannot be replaced. If the cord is damaged the power supply should be scrapped.
-
The sound pressure level is approximately 87 dB (A).
-
This appliance can be used by children from the age of 8 and people with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by
children without supervision. -
The supply cord of the USB charger cannot be replaced. If the cord is damaged the USB charger should be scrapped.
-
The pump contains batteries that are non-replaceable.
-
Do not modify the product
ASSEMBLY AND USE OF THE PUMP:
- The ON/OFF switch is marked with the symbols (I) and (O). (I) is the ON position.
- The pump must be charged before use. The pump is not operatable while charging.
- Remove the charge port cover, insert the DC plug (7.) into the charge port (3.).
- Plug the charger into a suitable power source (5V DC USB)
- A full charge takes app. 5 hours. Charge the pump for at least 5 hours before the initial use.
- The battery indicator on the USB charger (5.) will light red when charging. It will light green, when the battery is fully charged.
- Don’t empty the battery completely before recharging. Doing this will shorten the battery life. Instead charge the battery when the pump has been used for some time.
- When the pump has been charged, unplug the DC plug and re-fit the charge port cover on the charge port (3.)
Select a suitable nozzle (4) and attach it to the inflation port (9), or
deflation port (8), depending on whether you wish to inflate or deflate.
Attach the nozzle to the valve on the inflatable device, and press (I) on the
switch.
Pay special attention to warnings #2 – #4.
When deflating it might be necessary to pinch the valve with your fingers to
open the flapped inside the valve to allow air to escape.
Maintenance:
The pump can be cleaned with a damp rag. Allow the pump to dry completely
before using again.
Do not use corrosive liquids to clean the pump.
Instruction for disassembly of pump for disposal of components when pump has reached the end of its usable life:
- Remove the nozzles (4). Dispose of the nozzles as plastic according to local regulations
- Dispose of pump unit, AC/DC and 12V chargers as electric waste according to local regulations Pump unit contains a Ni-MH battery.
Technical data pump:
5V 400mA
Class 3 appliance
Technical data USB charger:
Input: 5V 50/60Hz, 0.2A
Output: 5V 400mA, 2W
Class 2 appliance
Outwell® is a reg. trademark of Oase Outdoors
EU: Kornvej 9, DK-7323 Give, Denmark
UK: One Glass Wharf, Bristol, BS2 0ZX
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>