JETBeam M37 Highlight Long Range Flashlight 340M Instruction Manual
- June 5, 2024
- JETBeam
Table of Contents
JETBeam M37 Highlight Long Range Flashlight 340M
Features
- Designed for military, police, law enforcement, adventure and outdoor use.
- 3,000 lumen max output with 340 meters throw
- Powered by two USB-C rechargeable 18650 batteries with a runtime reaching up to 48 hours for endurance applications.
- The top of the attack head rim is equipped with three ultra-high hardness zirconia ceramic beads, which help to break the window quickly.
- Three constant brightness modes + strobe.
- Rated IPX8 waterproof, 2m submersible, and 1m drop resistant.
- Constructed from aerospace- grade aluminum alloy.
- HAIII Military Grade Hard anodized finish.
Specification
- LED: CREE XHP50.3
- Maximum output: 3000 lumen
- Reflector: Orange reflector
- Lens: Coated mineral glass
- Barrel body: aerospace- grade aluminum alloy
- Barrel Finish: Military grade 3 hard oxidized / micro-arc oxidized white
- Battery: 1*18650
- Switch: Tail switch
- Length: 143mm
- Head diameter: 37.5mm
- Tail diameter: 25.5mm
- Weight: 132.5g (without battery)
Battery For Use
| Type| Nominal Voltage| Compatibility
---|---|---|---
Rechargeable Lithium battery| 18650 power battery| 3.7V| Yes (recommended)
Rechargeable Lithium battery| 16340| 3.7V| NO
Output & Runtime
| FL1 SRTANDARD | High | Medium | L ow | Strobe |
|---|---|---|---|---|
| 3000LM | 600LM | 30LM | 3000LM | |
| 1.8h | 2.8h | 48h | – | |
340m
|
28800cd
|
1.5m
|
IPX8
In The Box
- 18650 3500mAh USB-C rechargeable li-ion battery
- O rings
- Lanyard
- USB charging cable
- Clip
NOTE
- The above data is in accordance with the international flashlight measurement standards ANSI/NEMA, FL1 described in the measurement method, the use of a JETBeam 18650 3500mAh (3.7V) rechargeable lithium batteries in the laboratory measurements, different batteries or use of the environment may have an impact on the above data;
- The flashlight in the opening of the 1-minute high brightness mode will be activated after the self downshift function. To prevent overheating and effectively protect the LED life, when the temperature is too high, the flashlight starts to slowly downshift, until the brightness is less than 70%, if you need to use the super bright gear again, just turn off the flashlight and turn it on again.
WARNING
- Insert the batteries with the positive (+) end pointing forward, otherwise the light doesn’t work.
- Avoid direct eye contact with light as it will cause damage.
Operation Of Flashlight
Insert batteries
- Unscrew and remove the tail cap of the flashlight.
- Insert two 18650 batteries with the positive (+) end pointing forward.
- Replace the tail cap and fasten tightly.
- If you have installed the clip, please twist the threads on the other end of the flashlight when removing the batteries to prevent the clip from hanging on the flashlight.
ON/OF FS witching :
The flashlight can be turned on or off by pressing the switch at the end.
Mode Switch
When the flashlight is turned on, turn it off and then turn it on again
quickly (within 3 seconds) to switch to the next mode High-Medium-Low-High
without memory. Under the off state, touch the tail switch (half press)
continuously to select the mode and then press the switch to the bottom.
Strobe Mode:
Under the power off state, touch the tail switch twice quickly to enter the
flash mode.
Protection Function
Circuit with power down protection function, high gear will gradually
downshift after 1 minute to protect the circuit; Circuit with low voltage
downshift, low voltage step by step downshift to increase the running time and
protect the battery; Circuit with low voltage shutdown function, lower than
2.6V shutdown to protect the battery.
Storage And Maintenance
- Remove the batteries if light will be stored or unused for an extended time period.
- Store the flashlight away from fire and high humidity/salty environments.
- Clean the body with a soft cloth; lubricate threads and O-ring with silicon grease semi-annually.
Warranty
- Within 15 days of purchase, free replacement is provided by seller.
- JETBeam offers a 24 month (2 year) free warranty service from date of purchase. Buyer will only be responsible for shipping costs of item. After 24 months, buyer is responsible for replacement parts as well as shipping costs.
Unwarrantable
- Excessive damage, abuse, or neglect. Disassembly and unauthorized modifications.
- Damage caused by “no-name” /generic batteries that are not regulated
- Damage due to improper storage or battery leakage.
Service
- Contact your retailer or email us [email protected]. call us +86-755-28077748.
- Any update information will be displayed on www jetbeamlight.com, and which we reserve the right to change information.
Customer Support
For more information, please follow us on facebook: JETBeam.
JET Beam Electronic Technology Co.,Ltd
E-mail : [email protected]
Tel: +86-0755-28077748
Fax: +86-0755-28175738
Website : www.jetbeamlight.com
Address : Dunbei Industrial Park, Dalang South
Road, Longhua Town, Shenzhen, China, 518109