ClimaRad Ventura V1C-S Instruction Manual
- June 3, 2024
- climaRAD
Table of Contents
ClimaRad Ventura V1C-S
Operating principle ClimaRad Ventura V1C-S
The ClimaRad Ventura V1C-S is equipped with sensors for CO, humidity, and indoor and outdoor temperature. They measure the air quality and automatically determine the required ventilation for each room. The device also features convectors, allowing the unit to ventilate, heat, and (optionally) cool.
Operating the ClimaRad Ventura V1C-S
The control panel is situated on the front of the device. You can find the function buttons and notifications of the panel in question on page 2 of this instruction manual. The ClimaRad Ventura V1C-S in your room is optimally configured by the installer and functions fully automatically. That is why we only explain the function buttons that are relevant for you during daily use.
Operating the ClimaRad Round
You can set the desired temperature yourself by turning the ring. Turn left for lower temperatures, turn right for higher temperatures.
Function Keys
Automatic control:
The ventilation, heating, and cooling systems in the room are automatically
controlled by your ClimaRad Ventura, which functions based on CO2 measurements
and temperature.
Temperature:
You can set the desired temperature yourself using the + and – on your control
panel in order to heat up or optionally cool down the room.
Pause:
Use this function if you want to stop ventilating temporarily. After a period
of 4 hours, your ventilation unit will reset to automatic control.
Ventilation (manual):
This function allows you to activate the ventilation function of your device.
You can then use the + and – on your control panel to configure the
ventilation speed. After a period of 8 hours, your device will reset to
automatic control.
No function.
Child lock:
This key combination locks your control panel. Press the indicated buttons
simultaneously for 4 seconds. If you want to unlock the device, repeat this
action.
Messages
- Child lock: The child lock is activated.
- Error: A fault has occurred. Please contact your installer or housing corporation.
- Dirty filter: Replace the air filters or contact your installer or housing corporation After replacing the filters, press the + and – buttons for 6 seconds.
Switch off
- Press 4 seconds simultaneously
- Press for 6 seconds
ClimaRad B.V. – Lübeckstraat 25 – 7575 EE – Oldenzaal – NL – info@climarad.com – www.climarad.co.uk – tel. +31 541 358130.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>