JETBEAM KO-02 2000 Lumen USB C Rechargeable EDC Torch User Manual
- June 16, 2024
- JETBeam
Table of Contents
JETBEAM KO-02 2000 Lumen USB C Rechargeable EDC Torch
Features
- Mainly used for outdoor camping, EDC, adventuring, searching & rescuing etc.
- Uses one CREE XHP35 LED with a lifespan of 50,000hours.
- Max output of 2000 lumens and throw distance of 285 meters.
- Strongly Magnetic Tail Cap For Hands-free Using.
- Powered by 121700 Li-ion battery, compatible with 120700 or 1*18650 battery.
- Side switch, five levels of brightness and strobe available.
- Built-in Type-C charging port.
- Digitally regulated circuit and intelligent temperature control system to optimize the performance and maximize LED lifespan.
- Low power indicator LED reminds the user of battery replacement and remaining power level.
- Reverse polarity protection to protect from improper battery installation.
- Toughened ultra-clear mineral glass with antireflective coating.
- Constructed from aero-grade aluminum alloy.
- Hall military-grade hard-anodized finish.
- Waterproof rating: IPX-8 (2 meters underwater).
- Within the impact resistance height of 1 meter.
- Magnetic tail cap with stand capability.
Specifications
- LED: CREE XHP35 LED
- Maximum output: 2000 lumens
- Reflector: orange reflector
- Lens: Coated toughened glass
- Body material: Aero-grade aluminum alloy
- Finish: HA III military-grade hard-anodized
- Battery: 121700/120700/1*18650 battery
- Switch: Side Switch
- Dimensions: 131.5mm (Length)x28mm (Head) x26.5mm (Tail)
- Weight: 110g (Without battery and bracket)
Battery for Use
| Ty pe| Nomina l Volta ge| C ompa tibility
---|---|---|---
Rechargeable
Lithium battery
| 21700| 3.7V| Yes(recommended)
Rechargeable Lithium battery| 20700| 3.7V| Yes
Rechargeable Lithium battery| 18650| 3.7V| Yes
OUTPUT & RUNTIME
Included for Free: O-ring, lanyard, clip, USB Type-C charging cable, 3.6V 5100mAh 21700 rechargeable Li-ion battery.
Operation of flashlight
Insert the battery
- Open the tail cover and remove the flashlight and battery from the package
- Insert the battery’s positive pole towards the head of the flashlight (the end where the LED is located)
- Tighten the end cap and insert the battery
WARNING:
- Please put the battery in the direction of the positive pole toward the lamp head, and the battery flashlight will not work if it is reversed
- Do not shine light directly on the eyes to avoid damage to the eyes.
On/Off
Short press the side switch to turn on, keep pressing the side switch for 0.5
seconds to turn off.
Mode Change
When the light is on, short press the switch can change the brightness mode,
cycling by Turbo–High–Mid-Low– Eco.
Strobe Mode
Double press the side switch will access strobe, press the switch again will
return off the strobe.
Power Indicator
When the light is turned on, The LED beneath the side switch will indicate the
battery level.
- Stay in Green, battery powerfully charged;
- Flash in Green, battery power is enough;
- Flash in Red, battery power is low;
- Keep in Red, battery power is extremely low and needs recharging.
Charging
Built-in Type-C charging port, Max input 5V lA. In the charging process, the
red LED under the side switch will flash, the green LED will be constant on
when charging is completely done.
Intelligent Temperature Control
Prolong the lifespan of LED and light with intelligent temperature control
design by stepping down the brightness automatically when light is too hot.
Low Voltage Brightness Adjustment
When the battery is low, the flashlight will automatically adjust the
brightness level to a lower level to extend working time. The flashlight will
be turned off when the battery is too low.
Lock and unlock
When the light is off and unlocked state, long press the switch, the
flashlight flashes twice will enter the lock state; in the lock state, click
or double click, the flashlight flashes once means the light is in the lock
state. Keep pressing till the flashlight flashes two times unlocked into
standby.
Light Maintenance
- Take the battery out for storage if light will not be used for a long time
- Keep the light away from heat, static electricity, and high humidity
- Clean the thread and conductive contact of light with soft cloth. Lubricate the threads every 6 months
Warranty
We provide 60 months (5 years) of wananty period for this product from the date of purchase in case defects caused by material or workmanship with normal use. Necessary material and labor cost will be charged after this period
Free warranty does not cover any damages or failure if:
- This product is disassembled or modified by anyone other than an authorized JETBeam wananty technician.
- This product is damaged by using the wrong battery or incorrect usage.
- This product is damaged by defective batteries (such as battery leak).
- Salt water and corrosive damage to the unit.
Service
- In need of warranty service, please contact your local official JETBeam dealer
- To contact JETBeam, please refer to below information:
Email:info@jetbeamlight.com
Phone:+86-0755-27523445
For the latest update, please visit
www.jetbeamlight.com
Documents / Resources
|
JETBEAM KO-02 2000 Lumen USB C Rechargeable EDC
Torch
[pdf] User Manual
KO-02 2000 Lumen USB C Rechargeable EDC Torch, KO-02, 2000 Lumen USB C
Rechargeable EDC Torch, USB C Rechargeable EDC Torch, Rechargeable EDC Torch,
EDC Torch, Torch
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>