DPA MICROPHONES 4017C Shotgun Microphone Owner’s Manual
- June 3, 2024
- DPA MICROPHONES
Table of Contents
DPA MICROPHONES 4017C Shotgun Microphone
4017C Shotgun Microphone
A combination of the MMC4017 microphone capsule and the MMP-C preamplifier,
the 4017C Shotgun Microphone is part of the Pencil Microphone Series.
Performance
The supplied calibration chart shows the specially tailored individual
frequency response of the MMC4017 capsule, measured with a linear MMP-C preamp
.
Typical on- and off-axis frequency response of MMC4017
Typical directional characteristics of an MMC4017
dpamicrophones.com/4017
Service & Repair
If you are not satisfied with the characteristics exhibited by this product,
please contact your nearest DPA Microphones representative for support.
Warranty
4017C is covered by a five-year limited warranty.
CE marking
This product conforms with all relevant directives approved by the European
Commission.
Specifications
-
Directional pattern
-
Supercardioid, lobe-shaped
-
Principle of operation
-
Pressure gradient, with an interference tube
-
C apsule type
-
Pre-polarized condenser
-
Frequency response
-
20 Hz to 20 kHz
-
Effective frequency range, ± 2 dB, at 60 cm (23.6 in)
-
40 Hz to 18 kHz with typ. 3 dB soft boost at 15 kHz
-
Sensitivity, nominal , ± 2 dB at 1 kHz
-
19 mV/Pa, -34.4 dB re 1 V/Pa
-
Equivalent noise level, A-weighted
-
Typ. 13 dB(A) re. 20 µPa (max. 15 dB(A))
-
Rated output impedance: < 100 Ω
-
Output balance principle
-
Impedance balancing with Active Drive
-
Common Mode Rejection Ratio (CMRR): 50 dB
-
Power supply (for full performance): P48 (Phantom power)
Current consumption: 2.8 mA -
Polarity
-
+V at Pin 2 for positive sound pressure
-
Connector
-
XLR-3M. Pin 1: Shield, Pin 2: signal + phase, Pin 3: signal – phase
-
Weight: 40 g (2.5 oz)
-
Temperature range: -40 °C to 45 °C (-40 °F to 113 °F)
-
Relative humidity: Up to 90%
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>