DOORsafe WFi and 433 MHz Chime Plus Alarm Instruction Manual

Table of Contents

Switch on the transmitter by sliding the switch to ON inside the transmitter.
Connect the 2 wires coming from the transmitter to the doorbell or the screen.
The transmitter works on a 3V CR2032 button cell battery. Loosen the screw to be able to replace this battery.
Plug the chime into a 110 – 220 Volt socket.
The gong contains a 3.7V 300mAh Lithium battery that can keep the gong working for 5 hours in the event of a power failure.
The chime can connect to a 2.4 Ghz Wi-Fi 802.11b/g/n network.
Connect the transmitter and alarm sensors with a 433Mhz wireless signal to the chime.
Up to 100 sensors and 10 remote controls can be connected to the chime
The chime has 58 different ringtones.
The chime has 5 different volumes including silent.
The maximum volume is 85dBA
Operating temperature: -10 ~ 55 C.

There are 2 ways to pair the transmitter or an alarm sensor with the chime:

Without the app
- Long press the bottom button with the musical note.
  The LED ring will flash purple.
- Now trigger the transmitter or the sensor 1 time. The LED ring flashes green 2 times.
Via the app
- Add chime to the app
- Open the app
- Select: ‘Accessors’
- Select: ‘+’
- Now trigger the transmitter or the sensor 1 time.The LED ring flashes green 2 times.
- Set the type per sensor
- Set the Zone mode
  Zone modes:
- + Delay: only active after the delay time
- + Normal: directly active at ‘Away Arm’
- + Home: not active with ‘Home Arm’
- 24 hours: always active (e.g. smokesensor)
- + 24 hours silent: always active, silent alarm

Download the app:

Turn on BLUETOOTH of smartphone
Press 1 x long on the middle button on the chime with the WiFi symbol: the LED ring then quickly flashes blue
Chime is now sending out a Bluetooth signal
Connect a smartphone to 2.4Ghz WiFi & enter your own WiFi password
In the app, choose: ‘Add Device’ or ‘+’ and ‘Add Device’
The gong will appear at the top of the app
Choose ‘Add’ and then ‘Next’
If necessary, give chime a different name.

Open the app
Chime & doorbell should both be added to the app to be able to set this scenario.
Select: ‘Scene’ (in app menu bar below)→Select: ‘Create Scene’
Select: ‘When device status changes’
Select: Doorbell out of the list
Select: ‘Door call’ & ‘Start’
Select: ‘AddTask’ at ‘Then’
Select: ‘Run the device’
Select: Chime out of list
Select: ‘Chimes from 1 to 31’ or ‘Chimes from 32 to 58’ and select a ringtone that you like and press ‘Save’ & ‘Next’.
Check the scenario & select: ‘Save’
Select: ‘Yes’ to start using this scenario.
Press the green switch to turn this scenario on or off.
Add a Schedule to the If scenario to make the chime ring only during a certain sched- ule, e.g. only on Mondays during 9 and 17.
Add a Location to the If scenario to make the chime ring only when e.g. you are at home.
Add a Delay to the Then scenario to make the chime ring only after a certain time.
Switch on the transmitter by sliding the switch to ON inside the transmitter.
The transmitter works on a 3V CR2032 button cell battery. Loosen the screw to be able to replace this battery.
Connect the 2 wires coming from the transmitter to the doorbell or the screen.