NIX Hydration Biosensor POD User Manual

NIX Hydration Biosensor POD

Revision History

Control and visualization elements

1. RGB LED
2. Tactile switch

Create account

The first step when opening the app for the first time is to create a user account

Log in

Once the user account is created or if one already exists, you must log in .

Get Started

Create your profile

Some personal information must be entered in order to create personalized results:

Information that may be sensitive to some users can be omitted

Pairing

After creating your profile, it is necessary to perform the pairing process with the pod, for this must be pressed and hold the tactile switch for 5 seconds until LED turns blue, then release the button and wait until the app completes the process.

Start a Workout

To start a workout, touch the play button and follow the instructions

If the pod has a patch installed, the LED shows green with a slow blinking (once per second) and jumps to workout configuration; otherwise, the LED indicates green with a fast blinking (five times per second) and shows a message asking to insert the pod in the patch.

You can choose the type of drink or continue with the process

Once the workout configuration is finished, you must press the start workout button

The workout is run (LED shows no color)

End the workout

To end a workout, you must press the stop button located at the bottom center of the screen.

A confirmation message appears before stopping the workout

To end the workout the pod must be removed from the patch

The data of the last workout is available

Meaning of the RGB LED

• Blue
  Pairing between Nix Pod and App.

• Green
  Your Nix Pod is ready for use.

• Amber
  Blinking – charging.
  Solid – fully charged.

• Red
  In workout – No patch detected or low battery.
  Post workout – No Battery.

FCC CERTIFICATE STATEMENT

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

IC-ID CERTIFICATE STATEMENT
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>