DEPRAG D52-ADC Dental Milling Machine User Manual

June 3, 2024
DEPRAG

DEPRAG D52-ADC Dental Milling Machine

Networking Instructions

  1. The LAN1 port is a local area network interface. If you need to use a local area network, the LAN1 port should be connected to a computer or switch.
  2. Set the IP and select the subnet mask method
  3. Enter the background, Set the IP1 address and subnet mask according to the on-site IP network segment and subnet mask setting format. (The input of the IP address needs to be connected to the keyboard of the USB interface)
  4. Restart the device after saving the settings.
  5. Unzip the transmission software package, find the FTP application file, and double-click to open it.
  6. Open the FTP interface as follows, set the name and the same IP address as the system.
  7. Click the “+” button, and then click the “read” button. The green “read current task 100%” is displayed below, indicating that the connection is successful.
  8. Find the NC file to be transferred in the Hard Disk Drive, click the “Join” button, then click the “send” button, and click “OK” to send the NC file to the local memory and schedule list of the device.
  9. The following figure shows the successful sending status.
  10. The LAN2 port is the Internet interface. If you need to use the Internet, you should connect the LAN2 port to a computer or switch.
  11. Internet connection method
  12. When the customer site network is set to automatically capture IP, the network cable can be directly inserted into the LAN2 port to achieve network connection.
  13. When customers use a static IP address, need to provide the following information: ip_address, netmask, gateway, dns, and send the above information back to the manufacturer. After configuring the updated network file, update it to achieve network connection.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals