Skullcandy Venue User Manual

: June 2, 2024
: Skullcandy

USER MANUAL

Skullcandy Venue

Skullcandy Venue

Power On/Off

Power - On / Off

Pairing Mode

Pair New Device

Pairing Mode

Volume Up

Volume Up : Volume +

Volume Up

Volume Down

Volume Down : Volume –

Volume Down

Play/Pause

Track Forward

Track Back

Answer/ End Phone Calls

Activate Voice Assistant

Charge

Rapid Charge:

Rapid Charge: 10 minutes = 5 hours

Rapid Charge

Check Battery Life

ANC-Off

Active Noise Canceling (ANC) Off

ANC-Off

ANC-On

Active Noise Canceling (ANC) On

ANC-On

Monitor Mode On I Off

Monitor Mode – On / Off

Monitor Mode - On / Off

Tile Enabled:

Download the App

Pair Tile

Bluetooth Functions Disabled with Aux Cable

Bluetooth Functions

Microphone Function with Aux Cable

Answer/ End Phone Calls

Questions Visit: www.skullcandy.com

ISED Statement

This device contains licence-exempt transmitter(s) /receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:

(1)This device may not cause interference.

(2)This device must accept any interference, including interference that may cause undesired operation of the device.

ISED SAR Statement

This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. End user must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The portable device is designed to meet the requirements for exposure to radio waves established by the ISED. These requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value reported under this standard during product certification for use when properly worn on the body.

FCC SAR Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End user must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The portable device is designed to meet the requirements for exposure to radio waves established by the Federal Communications Commission (USA). These requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value reported under this standard during product certification for use when properly worn on the body.

The FCC Compliance Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna. – Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio /TV technician for help.

Specifications

Speaker Driver: 40mm,
Impedance: 32 Ohms, THD <1%@1KHz,
Voltage Regulation: 3.7v, Bluetooth® 5.0,
Frequency Band: 2402MHz–2480MHz@9.94dBm,
Maximum Power: 9.8dBm,
Weight: 232.5g. FR Driver