Sharper Image Aerial Acrobat Video Drone User Manual 205982

: June 2, 2024
: Sharper Image

Table of Contents

SHARPER IMAGE®
Read User Manual Online (PDF format)
Download This Manual (PDF format)

SHARPER IMAGE®

AERIAL ACROBAT VIDEO DRONE
Item No. 205982

Thank you for purchasing the Sharper Image Aerial Acrobat Video Drone. Please read these instructions prior to using this device for the first time.

FEATURES

LED lights
Glows in the dark
Auto hover
Headless mode (for beginners)
360° flips
One-button launch
One button return
3 speed modes
Includes 4GB memory card (supports up to 32GB)
Charge time: 90-120 minutes
Flight time: 7 minutes
Flight range: 98 ft.

BATTERY INSTALLATION (TRANSMITTER)

Open the battery cover and insert 4 AA batteries (included)
Follow polarity diagrams inside the battery compartment
Replace the battery cover

IDENTIFICATION OF PARTS (TRANSMITTER)

Identification of Transmitter Parts

PAIRING THE TRANSMITTER AND DRONE

Be sure the Transmitter has fresh batteries and the drone is fully charged
Turn on the Transmitter
Power on the drone by plugging the battery cable into the power outlet
The drone will beep once and the lights will stop blinking once it is paired with the remote
Once paired, in order to fly, place the drone on the ground and simultaneously push the throttle stick and direction stick forward, then diagonal down. This will get the propellers to start. Note: If the drone lights are blinking the item is not paired.

RESETTING THE GYROSCOPE

If the vehicle is flying erratically, you may need to reset the gyroscope
Hold both control levers down and pointed to the inside for 3 seconds
The vehicle lights will turn solid when the operation is complete

PROPER FLYING CONDITIONS

This vehicle can fly indoors or outdoors
Make sure ate there no obstacles nearby (furniture, trees, power lines, etc.)
When flying outdoors, fly in warm, sunny, calm conditions
Do not fly in rain, snow, hail or heavy wind

HOW TO CONTROL THE AIRCRAFT

How to control aircraft

TRIM CONTROLS

Trim Controls

STUNT FLIPS: 360° TUMBLING ACTION

Fly the vehicle to a height of at least 3 meters (9 feet)
Press the stunt button (upper right corner of transmitter, shown). And then, Push the right lever in any direction to do a forward tumble, backward tumble, left tumble or right tumble
If the vehicle crashes while attempting a stunt flip, please reset the gyroscope

AERIAL VIDEO AND PHOTOS

Insert SD card into the slot until it clicks into place
While drone is powered on, press Video to record video. Press again to stop recording
While drone is powered on, press Photo to take a single image. (Picture cannot be taken during video recording function.)

INDICATOR LIGHTS

Continuous flashing red: Recording video
Red light stops flashing: Stops recording video
Red flashes once: Taking digital photo

To view videos and photos, power off the drone, remove the SD card and insert it into the included USB card reader. Then, insert the card reader into your computer USB port

CHARGING THE DRONE

The charging time is approximately 90-120 minutes
Switch the drone power off, then open the battery cover and remove battery
Connect the USB cable (Port B) to the computer USB port
Connect the battery to USB cable (Port A), you will see a red light turn off
Allow the battery to charge until the red light turns on again
When the red light comes on, the drone is fully charged

NOTES

Disconnect the cable when battery is fully charged
Do not leave a charging battery unsupervised
Use only the charging cable that came in this package
Wait until battery is cool before re-charging (about 30 minutes after flight)
Do not throw this battery into a fire, as it may explode
Do not short circuit this battery or expose it to some small metal parts, as this may cause accidents

HEADLESS MODE (EASY MODE)

Headless mode makes this drone easier for beginners to fly, because there is no specified “front end” or “rear end.” In Headless Mode, when you bank left, the drone banks left. When you bank right, the drone banks right, regardless of what direction the quad is facing.
To turn on Headless Mode

Switch to Headless Mode (button is on upper left side of transmitter).
You will hear a short “beep” and the indicator light will begin flashing. Now, the drone is in Headless Mode.
To turn off Headless Mode, press the Headless Mode button again. You will hear a short “beep” and the indicator light will stop flashing and remain continuously on.
Correcting forward direction: If the drone crashes while in Headless Mode, the direction of the aircraft’s indicator light will be the “forward” direction of the aircraft.
One key return: while in Headless Mode, press “one key return” and the aircraft will return to the operator. Press it again to exit this feature and resume normal flight.

SPEED MODE: Press to select Low, Medium, and High.
AUTO HOVER MODE: When you reach your desired altitude, release the throttle lever to maintain the altitude in auto hover mode.
ONE KEY LAUNCH: Press to begin with an automatic liftoff.
ONE KEY RETURN: Press to begin a slow descent and landing.

NOTE: As with all remote control toys, it may take some practice to become proficient in the use of this drone. Please be patient and observe all local laws concerning drone flights. Do not operate this vehicle in crowded areas. Do not operate this vehicle near streets, buildings, trees, power lines or airports.

FCC STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference
(2) this device must accept any interference received, including interference that may cause undesired operation.

WARRANTY / CUSTOMER SERVICE

Sharper Image branded items purchased from SharperImage.com include a 1-year limited replacement warranty. If you have any questions not covered in this guide, please call our Customer Service department at 1 877-210-3449. Customer Service agents are available Monday through Friday, 9:00 a.m. to 6:00 p.m. ET.

Sharper Image Trademark