GLOWSHIFT Dual Gauge Overhead T Top Pod for G Body Instruction Manual
- May 15, 2024
- GLOWSHIFT
Table of Contents
GLOWSHIFT Dual Gauge Overhead T Top Pod for G Body
Specifications
- Product Name: Dual Gauge Overhead T-Top Pod for G-Body
- Compatibility: G-Body vehicles
- Installation Method: Double-sided tape and screws
Product Usage Instructions
Step 1: Removal of Factory Trim
Start by removing the 4 screws on the factory T-Top trim using a Phillips head screwdriver.
Step 2: Surface Preparation
Clean the surface of the factory trim with an alcohol prep pad to remove any dirt and grease.
Step 3: Attaching the T-Top Pod
Remove the backing from the included double-sided tape on the T-Top pod and secure it to the factory trim.
Step 4: Reinstallation of Trim
Reinstall the trim and secure it to the vehicle with the factory screws.
Step 5: Gauge Installation
Follow the instructions included with each gauge to finalize the
gauge installation process. It may be necessary to drill a hole in
the factory trim to allow the wires to pass through.
Additional Information:
All GlowShift Products are subject to the GlowShift Limited Warranty. Please visit here to review complete Warranty, Terms, and Conditions.
Frequently Asked Questions
Q: Can this T-Top Pod be installed on any vehicle?
A: No, this specific T-Top Pod is designed for G-Body vehicles only.
Q: Do I need any special tools for installation?
A: You will need a Phillips head screwdriver and alcohol prep pads for installation.
INSTALLATION INSTRUCTION
Dual Gauge Overhead T-Top Pod for G-Body
- Start by removing the 4 screws on the factory T-Top trim using a Phillips head screwdriver.
- Clean the surface of the factory trim with an alcohol prep pad to remove any dirt and grease.
- Remove the backing from the included double-sided tap on the T-Top pod and secure to the factory trim.
- Reinstall the trim and secure to the vehicle with the factory screws.
- Follow the instructions included with each gauge to finalize the gauge installation process, it may be necessary to drill a hole in the factory trim to allow the wires to pass through.
All GlowShift Products are subject to the GlowShift Limited Warranty. Please visit https://www.glowshiftdirect.com/warranty-policies to review complete Warranty, Terms, and Conditions.
856.768.8300
Support@GlowShiftGauges.com
Rev. 2022
GlowShift Gauges, LLC 444 Commerce Lane Suite A, West Berlin, NJ 08091
GlowShift.com