hama 00222224 SANTA CRUZ Digital Radio Wall Clock User Manual

: June 1, 2024
: Hama

Table of Contents

hama 00222224 SANTA CRUZ Digital Radio Wall Clock
Product Information
Product Usage Instructions
FAQ
Controls and displays
Package contents
Safety instructions
Setup
Operation
Care and maintenance
Technical data
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

hama 00222224 SANTA CRUZ Digital Radio Wall Clock

Product Information

Specifications

Model: Digital Radio Wall Clock
Power Supply: DC 5V 1A
Remote Control: 1x CR2025
Input Voltage: 5.0V DC
Input AC Frequency: 50/60 Hz
Output Voltage: 5.0V
Output Current: 1.0A
Output Power: 5.0W
Average Efficiency During Operation: 73.6%
Efficiency at Low Load (10%): 69.7%
Power Consumption at Zero Load: 0.1W

Product Usage Instructions

Controls and Displays

1. Power supply unit connection socket

A. SET button
B. Up button
C.Down button
D.Alarm button

Important Information – Quick Reference Guide

Risk of electric shock symbol indicates a risk of electric shock from touching uninsulated product parts that may carry hazardous voltage.
Warning symbol is used to indicate safety instructions or to draw attention to specific hazards and risks.
Note symbol is used to indicate additional information or important notes.

Safety Instructions

Keep the product out of reach of children.
Do not mix old and new batteries/button cells or mix different types of batteries/button cells.

setup

4.1 Power Supply: Connect the power supply unit to the wall clock.

Warranty Disclaimer

Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper installation/mounting, improper use of the product, or failure to observe the operating instructions and/or safety notes.

Technical Data

Digital Wall Clock
Power Supply: Power supply unit
Remote Control: 1x CR2025

Trademark and Address

Trademark: Hama
Commercial Register Number: HRA12159
Address: Dresdner Str. 9, 86653 Monheim, Germany

FAQ

What should I do if the clock display is not working?
- If the clock display is not working, first check the power supply connection and ensure the batteries are properly inserted. If the issue persists, contact customer support for further assistance.
How often do I need to replace the batteries?
- The batteries in the remote control may need to be replaced when the remote control becomes unresponsive or when the range decreases significantly. It is recommended to use a new CR2025 battery for optimal performance.

Controls and displays

Power supply unit connection socket

A. SET button
B. Up button
C. Down button
D. Alarm button

Important information – Quick-reference guide:

This quick-reference guide contains the most important basic information, such as safety instructions and the steps necessary to operate the product.
To help protect the environment and conserve valuable raw materials, Hama does not issue a printed manual and instead makes this available exclusively as a PDF download.
The full text of the manual is available at the following internet address:
https://uk.hama.com -> 00222224 -> Downloads
Save the manual on your computer for reference and print it out if possible.

Explanation of warning symbols and notes

Risk of electric shock
- This symbol indicates a risk of electric shock from touching uninsulated product parts that may carry hazardous voltage.
Warning
- This symbol is used to indicate safety instructions or to draw your attention to specific hazards and risks.
Note
- This symbol is used to indicate additional information or important notes.

Package contents

Wall clock
Remote control
1x CR 2025 battery
Power adapter
These operating instructions

Safety instructions

The product is intended for private, non-commercial use only.
Use the product only for the intended purpose.
Protect the product from dirt, moisture and overheating and use it in dry environments only.
Do not use the product in the immediate vicinity of heaters, other heat sources or in direct sunlight.
As with all electrical products, this device should be kept out of the reach of children.
Do not operate the product outside the power limits given in the specifications.
Do not use the product in areas in which electronic products are not permitted.
Do not use the product in a damp environment and avoid splashing water.
Do not place the product near interference fields, metal frames, computers, TVs, etc. Electronic devices and window frames can negatively affect the product’s functionality.
Do not drop the product and do not expose it to any major shocks.
Do not modify the product in any way. Doing so voids the warranty.
Keep the packaging material out of the reach of children due to the risk of suffocation.
Dispose of packaging material immediately in accordance with the locally applicable regulations.
Only use the article under moderate climatic conditions.
The product is intended only for use inside buildings.
Route all cables so there is no risk of tripping.
Do not bend or crush the cable.
Always pull directly on the plug when disconnecting the cable, never on the cable itself.

Risk of electric shock

Do not open the device or continue to operate it if it becomes damaged.
Do not use the product if the AC adapter, the adapter cable or the mains cable are damaged.
Do not attempt to service or repair the product yourself. Leave any and all service work to qualified experts.

Warning – batteries/button cells

When inserting batteries, note the correct polarity (+ and – markings) and insert the batteries accordingly. Failure to do so could result in the batteries leaking or exploding.
Only use batteries that match the specified type. Keep the instructions for the correct choice of batteries included with the operating instructions of devices safe for future reference.
Before you insert the batteries, clean the battery contacts and the polarity contacts.
Do not allow children to change batteries without supervision.
Replace all the batteries in a set at the same time.
Do not mix old and new batteries, or batteries of different types or from different manufacturers.
Remove the batteries from products that are not being used for an extended period (unless these are being kept ready for an emergency).

Warning – batteries/button cells

Do not short-circuit batteries.
Do not charge batteries.
Do not burn batteries or heat them up.
Never open, damage or swallow batteries or allow them to enter the environment. They can contain toxic, environmentally harmful heavy metals.
Remove spent batteries from the product and dispose of them without delay.
Avoid storing, charging and using in extreme temperatures and at extremely low atmospheric pressures (such as at high altitudes).
Ensure that batteries with damaged housings do not come into contact with water.
Keep batteries out of the reach of children.
Do not swallow batteries or button cells. Burning hazard from hazardous substances.
If the battery compartment will no longer close securely, stop using the product and keep it away from children.
This product contains button cells. If the button cell is swallowed, serious internal burns can occur within 2 hours and ultimately lead to death.
If you suspect that a button cell has been swallowed or is in any part of the body, seek medical attention immediately.
Keep new and used button cells out of the reach of children.

Setup

Warning

Only operate the product from a socket that has been approved for the device. The socket must be installed close to the product and must be easily accessible.
Disconnect the product from the power supply using the On/Off switch – if this is not available, unplug the power cord from the socket.
If using a multi-socket power strip, make sure that the total power consumption of all connected devices does not exceed the socket strip’s maximum throughput rating.
If you will not be using the product for a prolonged period, disconnect it from mains power.

Power supply

Connect the power supply unit to the power supply connection socket (1) on the back of the wall clock.
Connect the mains lead on the wall clock to a properly installed socket.
The wall clock switches on automatically.

Operation

The display shows “0:00”. Briefly press the SET button (A) to switch to Settings mode. Set the following information in sequence: 12h/24h, hours, minutes, year, month, day.
To select the individual values, press the Up button (B) or the Down button (C) and confirm your selection by pressing the SET button (A).

Care and maintenance

Only clean this product using a lint-free, slightly damp cloth and do not use any harsh cleaners.
Ensure that no water is able to enter the product.

Warranty disclaimer

Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper installation/mounting, improper use of the product or from failure to observe the operating instructions and/or safety notes.

Technical data

(EU) 2019/1782

Hama GmbH & Co KG 86652 Monheim/Germany

Service & Support

www.hama.com
+49 9091 502-0

All listed brands are trademarks of the corresponding companies. Errors and omissions excepted, and subject to technical changes. Our general terms of delivery and payment are applied