Harbor Breeze SS86P-F60C-BK-M3 3-Ct 60 Lumen Solar Spotlights Instruction Manual
- June 8, 2024
- Harbor Breeze
Table of Contents
Harbor Breeze SS86P-F60C-BK-M3 3-Ct 60 Lumen Solar Spotlights
HARBOR BREEZE and logo design are trademarks or registered trademarks of LF, LLC. All rights reserved.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare
parts with package contents list. If any part is missing or damaged, do
not attempt to assemble the product.
Estimated Assembly Time: 10 minutes
FEELING CONFIDENT? START YOUR NEXT PROJECT
Visit www.lowes.com for more information
TOOLS REQUIRED
TROUBLESHOOTING
| PROBLEM | POSSIBLE CAUSE | CORRECTIVE ACTION |
|---|---|---|
| Solar light does not turn on at night or its nightly run time is shorter. |
- The solar light is not exposed to enough sunlight to fully charge the battery.
- The solar light is installed close to other light sources, which may keep the solar light from turning on at night automatically.
|
- Make sure the solar light is in an area where it receives the maximum amount of direct sunlight everyday. Keeping the solar panel clean is equally important to ensure maximum charging performance.
- Relocate the fixture or eliminate other light sources.
| 3. The battery is reaching the end of their useful life.| 3. Replace old battery with new lithium iron phosphate solar rechargeable battery.
WARRANTY
The manufacturer warrants this product to be free of defects in material and workmanship for one (1) year from date of original purchase. The manufacturer agrees to repair or replace the defective product, at its own option. This warranty does not include any costs associated with the physical installation, removal or return of the product. This warranty only extends to the original purchaser and is not transferable or assignable to subsequent purchasers. No warranty work will be provided under this warranty without reasonable proof of purchase. Please call us at 1-888-251-1003 to receive your warranty service. This warranty does not extend to the following: (1) LED bulbs or batteries; (2) defects caused by and resulting from misuse, neglect, accident or improper operation, maintenance and storage, disassembly of parts; (3) surface scratches or weathering as this is considered normal wear; (4) any other failure not related to defects in materials and workmanship. There are no other warranties except those stated above. Some states do not allow the exclusion or limitation of special or consequential damages or allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you. This warranty gives you specific legal rights, and you may have other rights that vary from state to state.
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install the product.
CAUTION
- This product contains lithium iron phosphate battery. Battery must be recycled or disposed of properly.
- Do not mix alkaline, standard (carbon zinc), or rechargeable (Ni-Cd, Ni-MH, etc.) batteries.
- Do not mix old and new battery. Ensure the battery is installed correctly with regard to polarity (+ and -).
- If the battery is reaching the end of its useful life, please replace old battery with new rechargeable battery.
- Battery should not be ingested.
- Do not dispose of battery in fire. Battery may explode or leak.
FEELING CONFIDENT? START YOUR NEXT PROJECT
CARE AND MAINTENANCE
- CHARGING THE BATTERY
For optimum performance, it is best to install the solar light in full sunlight and charge for 10-12 hours of full and direct sunlight with the switch in the “ON” position.
Note: the battery of solar flood light CANNOT be charged when placing the switch in the OFF position. Allow the light to run at least 8-12 complete charging and discharging cycles to reach battery’s maximum capacity.
PACKAGE CONTENTS
INSTALLATION OVERVIEW
HOW TO REPLACE BATTERY
Replace with one
brand-new 3.2V 18500 1000mAh LiFePO4 solar rechargeable battery (not
included).