VOLUAS Automatic Cat Feeders for Two Cats User Guide
- June 16, 2024
- VOLUAS
Table of Contents
VOLUAS Automatic Cat Feeders for Two Cats User Guide
1. Warranty
This Product has al year limited manufacturer’s warranty. Complete details of this product’s warranty and full terms can be found at www.voluas.com. For any questions please contact us at support@voluas.com. We will replay as soon as possible.
2. Important Safety Information
⚠ This is the safety alert symbol. It is used to alert you to potential
personal injury hazards.
AA Obey all safety messages that follow this symbol to avoid possible injury
or death.
WARNINC: Indicates a hazardous situation which, if not avoided, could result
in death or serious injury.
CAUTION: Used without the safety alert symbol, indicates a hazardous situation
which, if not avoided, could result in harm to your pet.
NOTICE: Is used to address safe use practices not related to personal injury.
⚠ WARNINC:
– DO NOT immerse control panel in water. Base unit should NOT be submerged in
water at any time, as this may damage electronic components.
– DO NOT place anything on top of the pet feeder. The unit starts
automatically. Keep clear.
– Dispose of all packaging materials properly. Some items may be packed in
polybags; these bags could cause suffocation; keep away from children and
pets.
– DO NOT allow small children to play with, in or around pet feeder.
– To reduce the risk of injury, close supervision is necessary when an
appliance is used by or near children.
– Intended for use with dogs or cats only.
– DO NOT use this pet feeder with puppies, kittens, dogs or cats not able to
reach the food tray or with any physical disability.
– DO NOT use outdoors. FOR INDOOR HOUSEHOLD USE ONLY. Check operation
frequently to be sure the pet feeder is dispensing properly.
– For dry food use only.
– DO NOT use wet, canned or moist food.
– Pet feeder should be placed on a level surface.
– Before leaving for extended time, always replace batteries with new
batteries.
– DO NOT place any foreign object in the pet feeder.
– DO NOT disassemble the pet feeder other than components as instructed in
this operating guide.
– To protect against electric shock, if using power cord do not place power
cord or plug in water or other liquids.
– Only use attachments recommended or sold by the manufacturer.
– DO NOT unplug by pulling on power cord. To unplug, grasp the plug, not the
power cord.
– DO NOT operate any appliance if it has a damaged power cord or plug, or if
it is malfunctioning or has been damaged. Call the Customer Care Center
immediately for further instructions.
– For a portable appliance – To reduce the risk of electrical shock, do not
place or store an appliance where it can fall or be pulled into a tub or sink.
-Always unplug any appliance when not in use, before putting on or taking off parts and before cleaning. Never pull on the electrical power cord to remove the plug from the wall outlet.
– DO NOT use an appliance for anything other than its intended use.
– If the plug of this device gets wet, turn off the electricity to that wall
outlet. Do not attempt to unplug.
– Examine this appliance after installation. Do not plug in if there is water
on the Power Cord or plug.
– To avoid tripping, always position power cord out of the way of foot
traffic.
⚠ CAUTION:
Do not allow pets to chew on or swallow any parts. If you are concerned about
the power cord, purchase a cord conduit (a hard plastic protector) at any
hardware store to protect the power cord.
3. Components
Note: Bowl and bowl holder are shipped inside feeder.
Note: Power Supply method:
(1). DC S.0V Power adapter & USB cable
(2). 3 D-cell alkaline batteries Required. Batteries NOT Included.
WHATS IN THE BOX
- Automatic Pet Feeder
- Power Adapter
- USB Power Cable
- Desiccant Bag
- Meal Divider
- Base Bracket
- Stainless Steel Bowl x 2
- Bowl Holder x 2
- User Manual
4. Features, Controls and Indicators
Feeding Schedule Setup:
4.1 Specifications
4.2 Key Definitions
6-BUITON NAVIGATION QUICK GUIDE
4.3 Quick Programming Guide
Note: Please ensure the feeder machine is powered on with DC 5.0V power
adapter and USB power cable or 3 D-cell alkaline batteries.
Note: Please ensure the control panel is unlocked.
Note: INDOOR HOUSEHOLD USE ONLY.
4.3.1 LOCK button.
4.3.2 MIC Button.
When enter the unlocked state and standby, pressing and holding this key” ” for 2 seconds then the “Low Battery/Mic” Led will turn red and speaker ring once, which prompts to start recording. When you release the” ” button, the recording ends. At the same time, your recording will be replayed. (Please keep pressing the key” ” during the whole recording process.)
4.3.3 SYSTEM TIME SETTING
4..3.4 MEAL TIME SETTING
E. Repeat process for additional meals.
F. Press and hold the” (SET)” button until it return to the unlocked standby
state.
Tips: In the above steps 1-14, if you press and hold the button for a long
time, it will directly return to the unlock standby state.
4.3.5 UP&DOWN BUTTON
A. UP Button.(“▲”)
Short press the”▲” key once, the set number will increase by 1. Long press to
quickly increase selection.
DOWN Button.(“▲ “)
Short press the”(▲)” key once, the set number will decrease by 1. Long press
to quickly increase selection.
4.3.6 FEED BUTTON
A. FEED Button. (” ? “)
In the unlocked state, short press once to manually feed a meal manually feed
a meal.
4.3.7 Note:
- There is a Low Battery indicator on the left side of the control panel. When you go out for extended period, check if the voltage indicator light is on. If there is a light or flashing light, please replace the battery to prevent your pet from starvation.
- DO NOT put your fingers into the machine at any time.
- This product uses 3 x D alkaline batteries.
- Please dispose of old batteries in accordance with national regulations (pay attention to environmental protection). When the feeder is not in use for extended periods, please remove the battery to prevent leaking battery fluid.
Do not add semi-dry or wet pet food, this product can only use dry pet food.
5.Prepare and Assemble Feeder
5.1 Assembling Bowl Holder& the Bowl
Pull the bowl holder out from the feeder food tank and install the bowl into
holder. Connect the holder and bowl to the machine.
Note:
For a better antioxidant effect, tear off the sealing film outside the small
package only when you use it.
5.2 Placing Desiccant Bag
The desiccant bag can remove the moisture or odor inside the tank, protect the
pet food from oxidation damage, and preserve freshness.
Note:
It’s recommended to change desiccant bag every 15 days to prevent mold. Please
remove the desiccant bag before cleaning the lid.
For a better antioxidant effect, tear off the sealing film outside the small
package and use immediately.
5.3 Connecting Power
-Insert the SV power adapter into a wall socket, Plug in the power socket of the feeder.
-Open the battery compartment at the bottom of the unit, and install 3 alkaline D batteries (not included) in case of outage.
-The LCD display will light up automatically indicating the feeder is on.
Note:
Battery NOT included.
Before connecting to power, make sure all parts are clean and completely dry.
The battery should power with an output of 4-SV; the battery level icon on the
display blinks on a low battery level(<4V).
5.4 Feeding Schedule Setup
(Refers to No.4.3 steps)
– Fill food tank with dry pet food. Close the lid and it will snap into place
due to gravity;
– Set the portion to 0, the meal will be cancelled.
Note:
Do NOT use canned, wet or moist pet food.
Recommend kibble size ranging from 2-l0mm/ 0.07-0.4in in diameter.
5.5 Filling Food Tank
-Fill food tank with dry pet food. Close the lid and it will snap into place due to gravity.
Note:
Do NOT use canned, wet or moist pet food.
Recommend kibble size ranging from 2-10mm/ 0.07-0.4in in diameter.
5.6 Recording A Meal Call
– Press and hold the “ ” button, start recording after beep.
– Release the button when finished, 2 beeps indicate it’s successfully
saved.10 second maximum recording length.
5.7 Manually Feeding Your Pet
Press the “ ? ” button and one portion (2½ tsp/125ml) will be fed each time.
5.8 Note:
The normal schedule and portion will not be affected.
6. Troubleshooting
The answers to these questions should help you solve most problems you may have with the pet feeder.
7. Replacement Parts and Accessories
7.1 Cleaning parts
It’s recommended to clean the feeder regularly for the continued good health
of your pet. The washable parts of the auto pet feeder are as follows:
1. Food tank. 2. Food tray. 3. Lid (without desiccant bag);
They can be submerged in water. Clean ONLY by hand-washing using cool or warm
soapy water.
7.2 Dissembling the food tank
If you have food inside the tank or chute outlet, press the Unlocked button on both sides of the machine and the press Feed button a few times to empty firstly. Press the food tank buckles with your thumbs and push the tank upward to disassemble.
Tiktok
Facebook
Twitter
YouTube
Instagram
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>