EARTHLITE SEDONA Pneumatic Back Tilt and Leg Break Salon Top Tables Instruction Manual
- June 1, 2024
- EarthLite
Table of Contents
EARTHLITE SEDONA Pneumatic Back Tilt and Leg Break Salon Top Tables
Specifications
- Product Name : Pneumatic Back Tilt Salon Top & Tilt Top Tables
- Assist Mechanism: Non-electric pneumatic
Product Usage Instructions
Pneumatic Back Tilt Control
- Locate the pneumatic back tilt handle on the right side under the back tilt.
- Ensure the handle is in the locking position.
- Squeeze/press the handle to release the pneumatic assist for adjusting the back tilt.
- While holding the handle, adjust the back tilt to the desired level.
- Release the handle to lock the back tilt in place.
Pneumatic Leg Break Control
- Find the pneumatic leg break control under the front section of the table.
- Check that the handle is in the locking position.
- Press the handle to activate the pneumatic assist for adjusting the leg break.
- Adjust the leg break to the desired position while holding the handle.
- Release the handle to secure the leg break in place.
New Pneumatic Back Tilt
Salon Top & Tilt Top Tables
Pneumatic tables come equipped with a non-electric pneumatic assist
mechanism. The following steps will guide you through operating the pneumatic
back tilt control and adjusting the back to the desired level.
-
Step 1
Locate the pneumatic back tilt handle, which is located on the right side under the back tilt. -
Step 2
The handle is set to the locking position. -
Step 3
Squeeze/press the handle to release the pneumatic assist, which allows you to move the back tilt up or down. -
Step 4
With the handle squeezed/pressed, move the back tilt to the desired level and re-lease the handle. It will lock in place.
New Pneumatic Leg Break
Salon Top, Leg Break
Tables with the pneumatic option come equipped with the same non-electric,
pneumatic assist mechanisms as mentioned above. The following steps will guide
you through operating the pneumatic leg break control.
-
Step 1
Locate the pneumatic leg break control, which is lo-cated under the front sec- tion of the table. -
Step 2
The handle is set to the locking position. -
Step 3
Squeeze/press the handle to release the pneumatic assist, which allows you to move the back tilt up or down. -
Step 4
With the handle squeezed/pressed, move the back tilt to the desired level and re-lease the handle. It will lock in place.
rev_1203_13_0200
FAQ
- Q: How do I know if the pneumatic assist is working correctly?
- A: You should feel a smooth release of pressure when squeezing/pressing the handle, allowing for easy adjustment of the back tilt or leg break.
- Q: Can I adjust both the back tilt and leg break simultaneously?
- A: It is recommended to adjust one mechanism at a time to ensure precise positioning and avoid potential strain on the pneumatic system.