VOLLRATH R39735A Cafeteria Breath Guard Instruction Manual
- June 1, 2024
- VOLLRATH
Table of Contents
VOLLRATH R39735A Cafeteria Breath Guard
One Piece Cafeteria Breath Guard
These instructions cover the installation of the one piece Cafeteria Breath Guard.
NOTE: Use caution when tightening the cap nuts. Overtightening may cause the plastic to crack.
- Install the breath guard uprights (A) to the studs (B) securing with cap nuts (C) as shown in Figure 1. Repeat for all four uprights.
- Install the breath guard support tube (D) between the uprights (A) securing with cap nuts (C) as shown in Figure 1. Repeat on the other side.
- Install the one piece breath guard (E) securing with screws (F) and cap nuts (C) as shown in Figure 1. Repeat for all four mounting locations.
- Install the side breath protector (G) to the support tube (D) securing with cap nuts (C) as shown in Figure 1. Repeat on the other side.
Three Piece Cafeteria Breath Guard
These instructions cover the installation of the three piece Cafeteria Breath Guard.
NOTE: Use caution when tightening the cap nuts. Overtightening may cause the plastic to crack.
- Install the breath guard uprights (A) to the studs (B) securing with cap nuts (C) as shown in Figures 1 and 2. Repeat for all four uprights.
- Install the breath guard support tube (D) between the uprights (A) securing with cap nuts (C) as shown in Figure 2. Repeat on the other side.
- Install the side breath guards (E) securing with screws (F) and cap nuts (C) as shown in Figure 2. Repeat for all mounting locations.
- Install the side shield (G) to the support tube (D) securing with cap nuts (C) as shown in Figure 2. Repeat on the other side.
- Install the support bar and stud assembly (H) to the side breath guards (E). Repeat for all mounting locations.
- Install the top breath guard (I) to the support bar and stud assembly (H) securing with cap nuts (C). Repeat for all mounting locations.
Diagrams Description
There are two diagrams provided, each visualizing the assembly process for the breath guards.
Figure 1: One Piece Breath Guard Installation shows the assembly of a one piece breath guard with labels A, B, C, D, E, F, and G corresponding to different parts of the guard and hardware used for installation.
Figure 2: Three Piece Breath Guard Installation shows the assembly of a three piece breath guard with additional components labeled H and I, indicating the support bar, stud assembly, and the top breath guard.
Specifications
| Item No. | 2350030-01 |
|---|---|
| Revision | 04/12 |
Contact Information
Vollrath Company, L.L.C.
1236 North 18th Street Sheboygan, WI 53081-3201 U.S.A.
- Main Tel: 800.628.0830
- Service Tel: 800.628.0832
- FAX: 800.752.5620
- Vollrath of Canada, Co.
- Tel: 800.695.8560
- FAX: 800.752.5620
- Website: www.vollrathco.com
FAQ
Q: What should I be cautious of during installation? A: Be careful not to overtighten the cap nuts as this may cause the plastic to crack. Q: Are the breath guard uprights installed on all four sides? A: Yes, the breath guard uprights are to be installed on all four sides, securing with cap nuts. Q: Is there a difference in the installation process between the one piece and three piece breath guards? A: Yes, the three piece breath guard has additional steps, including installing a support bar, stud assembly, and a top breath guard.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>