Nadoli BS-15436L-W3 Shower Base Installation Guide

Nadoli BS-15436L-W3 Shower Base

Retain these instructions for future use.

TECHNICAL DIMENSION

• Top view – Right corner
  

• Top view – Left corner
  

• Front view – Right corner
  

• Front view – Left corner
  

PARTS INCLUDED

Shower base

TOOLS AND MATERIALS REQUIRED

• Safety glasses

• Utility knife

• Pencil

• Shims

• Tape measure

• Drop cloth

• Allen Key

• Level
  

• Caulk gun

• Adhesive (1 tube)

• Sealant (1 tube)

• Drill

• Drill bit (Ø5 mm)

• 30mm screws Vis 30mm

• Extension bit holder Porte-embout

• Phillips bit

• 1/4″ v-notched trowel
  

 Lumber for additional wall studs if installing wall set; refer to wall set installation instruction
TIP : You may want to install insulation

REQUIREMENTS FOR SUCCESSFUL INSTALLATION

 Do not use drywall screws to secure flanges to wall studs. Product damage will occur and will void the warranty.
Entire bottom support must be in contact with a flat, level surface.

1. Read complete instructions before beginning installation.
2. Confirm that your model will fit in intended location and plumbing fixtures are located where required before beginning installation.
3. Walls and sub-floor must be solid, plumb, and square.
4. If installation surface is not level, use leveling compound or mortar bed for proper installation.
5. Use drop cloth to protect bathtub from damage during installation.
6. Two people recommended to install this product.

ROUGHING-IN

• Rough plumbing must be installed before shower base installation.
  

• Studs must be plumb and square.
  

INSTALLATION

Do not install the product with any air gaps under the bottom support or product damage will occur.
TIP: If installation surface is not level, use leveling
compound or mortar bed for proper installation.

Verify straight and square.

Mark stud locations.

Plumber’s putty will degrade bathtub material. Do not use plumber’s putty to seal between drain and bathtub. Use latex/acrylic sealant or a gasket.

TIP: Place drop cloth in bathtub and stand inside
bathtub to press it to floor when securing to wall studs.

LIMITED WARRANTY

By choosing a NADOLI product, a leader in the plumbing industry, you are sure to make the right choice. On top of the quality materials that are used to make their products, NADOLI’s advanced manufacturing processes also benefit its products’ quality and longevity. To attest to this, they decided to offer their customers a beneficial warranty.
We certify that our products will meet your needs with their style, but also with their manufacturing quality. To make sure that they are reliable and safe, each product was carefully inspected, tested and approved during the quality control process that is in place.

To whom does this warranty apply?

NADOLI offers a 10-year limited warranty on shower bases and doors from the date of purchase, exclusive to the first buyer as long as he/she resides in the same property. The warranty is intended for residential and/or domestic use.

Care instructions

Clean the product with water and a mild detergent. Abrasive or corrosive cleaners, steel wool, acetone, dry cleaning products or ammonia compounds must never be used to clean the product. If a shower mat is used, it must be removed right after each use. We recommend the use of cleaning products that are made for acrylic specifically

What is covered by the warranty?

fiberglass against manufacturing defects
Shower doors| Wheels, handles, diverter, screws, rails, towel bars and guide| Tempered glass

*From the date of purchase.

Should there be any manufacturing defects that are not covered by the warranty, the product will need to be inspected prior to following through with the claim. Without that verification, the brand will assume no charge and/or responsibility

What are the exclusions?

This warranty is applicable on all NADOLI products purchased on or after January 1st, 2018.

The warranty doesn’t apply if the product is damaged as a result of misuse, overuse or non-residential use, neglect, lack of maintenance, or the use of corrosive or abrasive products, regardless of the person who did those damages. The warranty does not cover shipping and labour costs. The warranty does not apply to the normal tear and wear of the goods.

The warranty doesn’t cover the damages caused by the acts of God or breakage resulting from a shock or mishandling, regardless of the part played by the buyer or the installer. It also excludes the damages caused by an improper installation.

NADOLI doesn’t cover damages caused by a water leak, even if they result directly or indirectly from a product defect, except where the applicable legislation does not allow any exclusion or limitation following indirect or consequential damages.

It is fair to say that if the product has a manufacturing defect, it will show as soon as it is installed or shortly after. However, a leak caused by an improper installation could happen a long time after. Therefore, it is strongly advised to have it done by a professional.
All warranty claims must include the invoice copy.

Should a part or product component be defective or the finish damaged following a normal domestic and residential use, NADOLI commits to replacing the defective part(s) to the first buyer only. NADOLI could also, in its sole discretion, commit to offer a full replacement. No indemnity shall be claimed for loss of enjoyment of life, loss of income or losses caused by water.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>