Alera JC-70UEL-F Beverage Cooler User Manual
- June 1, 2024
- Alera
Table of Contents
- Alera JC-70UEL-F Beverage Cooler User Manual
- GENERAL SAFETY RULES
- Packing List
- Unpacking Your Beverage Center
- Leveling Your Beverage Center
- Proper Air Circulation
- Drip Tray
- WARNING:
- Normal Operating Sounds You May Hear
- Proper Beverage Center Care & Cleaning
- Cleaning and Maintenance
- To avoid electric shock, always unplug your beverage center before
- Power Interruptions
- Vacation and Moving Care
- Troubleshooting
- Control Panel does not respond
- Beverage Center Does Not Operate
- Temperature appears too warm
- Temperature is too cold
- Beverage Center runs too frequently
- Moisture build up on interior or exterior of the beverage center
- Beverage Center door does not shut properly
- IMPORTANT
- Read More About This Manual & Download PDF:
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
Alera JC-70UEL-F Beverage Cooler User Manual
GENERAL SAFETY RULES
Before you use your refrigerator, please read this owner’s manual
carefully.
Use this appliance only for its intended purpose as described in this
owner’s manual.
DANGER : Risk of child entrapment. Before you throw away your old
refrigerator or freezer: Take off the doors.
Leave the shelves in place so that children may not easily climb inside.
The appliance must be correctly installed and connected to the power supply in
accordance with the installation instructions before it is used.. (See:
“Installing Your Beverage Center”).
The main power supply must be properly grounded.
This refrigerator must be positioned so that the plug is accessible. Never
unplug your unit often by pulling on the power cord. Always grasp the plug
firmly and pull straight out from the outlet.
Do not use an extension cord as this can negatively affect the performance of
the unit.
When transporting the refrigerator, keep the unit in the upright position. Do
not tilt the appliance beyond 45° or place the unit in upside down position.
Do not tip over.
Do not touch the cooled surfaces while the appliance operates, especially not
with wet hands, because the skin may stick to the cold surfaces.
It is recommended that the refrigerator is positioned away from any
combustible sources such as gas, petrol, alcohol, lacquer and banana oil, etc.
The aforementioned objects should not be stored in the refrigerator under any
circumstances.
If the unit fails to cool properly, dispose of spoiled food as needed.
Unplug your unit before cleaning or before making any repairs. NOTE: If for
any reason this product requires service, we strongly recommend that a
certified technician perform the service. Repairs made by non-qualified
personnel will void the warranty.
Do not defrost the appliance with other electric devices (hair dryer etc.) and
never scrape the ice or frost layer with sharp tools. Warning: Do not damage
the refrigerant circuit.
The rating plate is inside the appliance or outside on the rear or side wall.
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety. Children should
be supervised to ensure that they do not play with the appliance.
Do not run cord over carpeting or other heat insulators. Do not cover the
cord. Keep cord away from traffic areas, and do not submerge in water. If the
supply cord is damaged, it must be replaced by the manufacturer or its service
agent or a similarly qualified person in order to avoid a hazard. Repair or
replace immediately all electric service cords that have become frayed or
otherwise damaged. Do not use a cord that shows cracks or abrasion damage
along its length, the plug or the connector end.
Do not operate your refrigerator in the presence of explosive fumes.
WARNING–Do not use the flame or catch the fire near the unit.
DANGER-Risk of fire or Explosion. Flammable Refrigerant Used. To Be Repaired
Only By Trained Service Personnel. Do Not Puncture Refrigerant Tubing.
Caution–Risk of fire or Explosion. Dispose Of Property In Accordance With
Federal Or Local Regulations. Flammable Refrigerant Used.
CAUTION – Risk Of Fire Or Explosion. Flammable Refrigerant Used. Consult
Repair Manual/Owner’s Guide Before Attempting To Service This Product. All
Safety Precautions Must be Followed.
CAUTION – Risk Of Fire Or Explosion Due To Puncture Of Refrigerant Tubing;
Follow Handling Instructions Carefully. Flammable Refrigerant Used.
Staple your receipt to your manual.
You will need it to obtain warranty service.
Packing List
No.
| ****
Description
| ****
Quantity
---|---|---
1
| ****
Manual
| ****
1 pc
2
| ****
Screw hole plug
| ****
1 pc
3
| ****
Door shaft hole plug
| ****
1 pc
Parts and Features
- Interior Light
- Glass Shelves (1)
- Bclak Wire Shelf (2)
- Adjustable Leveling Legs
- Touch Control Panel
- Tinted Double Pane Glass Door
- Drip Tray in Back (not shown)
Unpacking Your Beverage Center
- Remove all packaging This includes the foam base and all adhesive tape holding the beverage center accessories inside andoutside.
- Inspect and remove any remaining packing, tape or printed materials before powering on the Beverage
Leveling Your Beverage Center
Your Beverage Center has two leveling legs which are located in the front
corners. After properly placing your Beverage Center in its final position,
you can level your beverageand and wine center.
Leveling legs can be adjusted by turning them clockwise to lower your Beverage
Center or by turning them counterclockwise to raise your Beverage Center. The
Beverage Center door will close more easily when the two front leveling legs
are extended slightly.
Proper Air Circulation
To ensure that your Beverage Center works at the maximum efficiency it was designed for, you should install it in a location where there is proper air circulation and electrical connections.
The following are recommended clearances around the beverage center:
Sides………………. 2″ (50mm)
Top…………………. 2″ (50mm)
Back………………… 2″ (50mm)
Do not over fill your Beverage Center for proper cooling.
Note: If your Beverage Center has been tilted for any reason, wait 4 hours before plugging it in.
Drip Tray
Ensure the drip tray in the rear of the unit is in the proper position.
WARNING:
Electrical Requirement
Installation Limitations
Use of Extension Cor
Using Your Beverage Center
Shelving (See Fig. #2)
To remove or replace a full-width slide-out shelf:
- Gently tilt the shelf up and slide forward until the shelf has been completely
- To replace the shelf, gently slide the shelf
Normal Operating Sounds You May Hear
- The sounds of boiling water and gurgling or the slight vibrations are the result of the refrigerant circulating through the cooling
- Compressor makes operational sounds when cycling on and
Proper Beverage Center Care & Cleaning
Cleaning and Maintenance
Warning: Caution:
To avoid electric shock, always unplug your beverage center before
cleaning. Ignoring this warning may result in dire consequences.
Before using cleaning products, always read and follow manufacturer’s
instructions and warnings to avoid personal injury or product damage.
General: Prepare a cleaning solution of 3-4 tablespoons of baking soda
mixed with warm water. Use sponge or soft cloth, dampened with the cleaning
solution, to wipe down your beverage center.
Rinse with clean warm water and dry with a soft cloth.
Do not use harsh chemicals, abrasives, ammonia, chlorine bleach, concentrated
detergents, solvents or metal scouring pads. Someof these chemicals may
dissolve, damage and/or discolor your Beverage Center.
Door Gaskets: Clean door gaskets every three months according to general
instructions. Gaskets must be kept clean and pliable to assure a proper
seal.Petroleum jelly applied lightly on the hinge side of gaskets will keep
the gasket pliable and ensure a good seal.
Defrosting Your Beverage Center
Your Beverage Center is designed with a manual defrost system. The Beverage Center surfaces will defrost, when the unit is unplugged. Water from the unit is disposed of automatically, by means of being channeled onto a drip tray located on the compressor. Heat transfer from the compressor causes this water to evaporate.
Power Interruptions
Occasionally there may be power interruptions due to thunderstorms or other
causes. Remove the power cord from AC outlet when a power outage occurs. When
power has been restored, replug power cord to AC outlet.
The unit will revert to the factory setting of 46ºF after any power outage.
Reset your temperature selection.
Vacation and Moving Care
For long vacations or absences, empty contents from Beverage Center, unplug theunit and clean the Beverage Center and door gaskets according to “General cleaning” section. Prop doors open, so air can circulate inside. When moving, always move the Beverage Center vertically. Do not move with the unit lying down. Possible damage to the sealed system could occur.
Troubleshooting
Control Panel does not respond
Check if control panel is on.
Beverage Center Does Not Operate
Check if Beverage Center is plugged in.
Check if there is power at the ac outlet, by checking the circuit breaker.
Check if power pad is on.
Temperature appears too warm
Frequent door openings.
Allow time for recently added beverages to reach proper temperature. Check
gaskets for proper seal.
Adjust temperature control to the require cooler stting.
Temperature is too cold
If temperature control setting is too cold, adjust to a warmer setting and allow several hours for temperature to adjust.
Beverage Center runs too frequently
This may be normal to maintain constant temperature in high temperature and
humid days.
Doors may have been opened frequently or for an extended period of time. Check
gasket for proper seal.
Check to see if doors are completely closed.
Moisture build up on interior or exterior of the beverage center
This is normal during the periods of high humidity. Prolonged or frequent door
openings.
Check door gaskets for proper seal.
Beverage Center door does not shut properly
Place Beverage Center on a level surface. Check for blockages.
Thank you for purchasing this product! If you have any questions about the
product, such as missing parts, damaged products, product assembling, and
operation, please contact us via Amazon Message or customer service
number: 213-4467172 or 661-4358826
| Thank you for purchasing this product! If you have any questions about the product, such as missing parts, damaged products, product assembling, and operation, please contact us via Amazon Message or customer service number: 213-4467172 or 661-4358826
IMPORTANT
Please call our customer service department for any consulting:
213-4467172
661-4358826
(8:30am – 5:30pm P.S.T.)
DATED PROOF OF PURCHASE IS REQUIRED FOR WARRANTY SERVICE.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>