ZAPAL B0BD3WQ13V Rechargeable Electric Heated Insoles User Manual
- June 14, 2024
- ZAPAL
Table of Contents
User Manual
Operation Instruction:
Charge
Please charge both insoles with the Dual-Type C charging cable when you receive the insoles, the LED indicator on the insoles will turn green when fully charged.
Turn on and temperature adjustment
Press to turn on the insoles by remote control, then set the desired heat
setting by pressing the corresponding button on the remote as below pictures.
IF THE INSOLES DO NOT RESPOND TO THE REMOTE
( Note: this is also applicable if you receive a new remote)
- Press the power button on each insole 3 times quickly until the LED indicator of each insole stars blinking.
- Press on the remote, the indicator on the insoles will stop blinking, the pairing well to control the insoles.
LED Display accurate temperature remote control (40℃ -65℃) or (104℉ -150℉)
Long Press “ON” to switch temperature modes ℉ and ℃.
● HEATING TEMPERATURE PARAMETER
(Tested at room temperature 77℉/25℃)
Select the desired heat setting by Pressing the button on the remote, the
insoles will fast heating to reach the desired temperature.
| Modes | LED Indicator | Heat Temp. | Heat time(Hs) |
|---|---|---|---|
| ℃ | ℉ | ||
| H | Red | 60-65 | 140-150 |
| M | Yellow | 50-59 | 122-138 |
| L | Green | 40-49 | 104-120 |
Sizing your heated insoles
There are size cutting lines on the underside of your heated insoles,
carefully cut along the line corresponding to you feet size (European and US
sizes are referenced), or your existing insoles as a template.
( Noted: Do not cut below the dotted lines as this may damage the insoles
and void the warranty)
Maintenace
- If you have not used the insoles for a long time, you need to charge them before using. Pleas charge the insoles at least one time every three months, it can help to extend the lifetime of the insoles.
- Brush surface of insoles with a little water, don’t immerse it into water. Better to keep its heel area upward to avoid water flowing into circuits. Once it ges wet, dry it in the air, it will work normally again.
- Don’t heat at high temperature over 60 a long time, it may hurt your feet.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>