SDH-DW5-BLK-NR Barn Door Hardware Classic Top Mount II Instruction Manual
- June 9, 2024
- BARN DOOR
Table of Contents
SDH-DW5-BLK-NR Barn Door Hardware Classic Top Mount II
INCLUDED IN KIT
| A | Door Roller Hardware | x4 |
|---|---|---|
| B | M8x60 Bolt | x9 |
| C | M8x30 Wall Anchor | x9 |
| D | Wall Bracket | x9 |
| E | M8x90 Bolt + Washer | x9 |
| F | Non-Routed Floor Guide | x4 |
| G | Floor Anchor | x8 |
| H | ST4.2×25 Screw | x8 |
| I | Door Stop | x4 |
| J | 2.5mm/4mm Allen Keys | x1 |
| K | Anti-Jump Disk | x4 |
| L | 68-7/8″ Rail | x2 |
TOOLS REQUIRED
- Plumb Line
- Pencil
- Phillips Head Screwdriver
- 10mm Drill Bit
- 10mm Routing Drill Bit
- 5.5mm Drill Bit
- Wrench
- Level
- Tape Measure
- Power Drill
NOTES To obtain maximum weight capacity, all fasteners must be mounted
into solid wood studs or wall blocking or mounted to a header board.
Consult a structural engineer if you have questions about what type of wall
blocking is required.
Mounting
-
Find the centerline of the track. Using a level, mark a horizontal line twice the door width long. Mark the bracket screw locations into the wall blocking. Attach the wall portion of the brackets as shown.
-
Join the two rails together. Fasten the door stops to the rail at this time, two in the center, two at each end. Attach the rail to the wall brackets using a wrench to fasten the bolts.
-
Drill holes in the top of the door 4″ from the edge as pictured to accommodate the door rollers.
-
Attach the anti-jump disks to the tops of the doors.
-
Attach the doors to the rails making sure that the anti-jump disks are engaged to avoid a serious accident.
-
Plumb the door and fastem the metal floor guides to the floor using the screws and anchors provided. The opening will depend on the thickness of your door. The guides are adjustable and will accept any thickness.
-
Adjust the door stops accordingly using the provided 2.5mm Allen key.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>