BARN DOOR HARDWARE SDH-SW6-BLK-NR Hardware Kit for Sliding Single Wood Door Installation Guide
- June 8, 2024
- BARN DOOR HARDWARE
Table of Contents
BARN DOOR HARDWARE SDH-SW6-BLK-NR Hardware Kit for Sliding Single Wood Door
MODEL No. SDH-SW6-BLK-NR
TOOLS REQUIRED
- Plumb Line
- Pencil
- Phillips Head Screwdriver
- 10mm Drill Bit
- 8mm Drill Bit
- Wrench
- Level
- Tape Measure
- Power Drill
INCLUDED IN KIT
A
| Door Roller Hardware| x2
---|---|---
B
| 78″ Rail| x1
C
| Wall Bracket| x5
D
| Door Stop| x2
E
| Allen Keys| x1
F
| Anti-Jump Disks| x2
G
| Non-Routed Floor Guide| x2
H
| Floor Anchor| x4
I
| ST4.2×25 Screw| x4
J
| M8x30 Wall Anchor| x5
K
| M8x60 Bolt + Washer| x5
L
| M8x90 Bolt| x5
DIMENSION
NOTES
Minimum door overlap on guide is 3-15/16″
To obtain maximum weight capacity, all fasteners must be mounted into solid wood studs or wall blocking or mounted to a header board.
Consult a structural engineer if you have questions about what type of wall blocking is required.
INSTALLATION INSTRUCTIONS
-
Find the centerline of the track. Using a level, mark a horizontal line twice the door width long. Mark the bracket screw locations into the wall blocking. Attach the wall portion of the brackets as shown.
-
Attach rail to wall as shown.
-
Drill out holes in the door as pictured.
-
Attach the anti-jump disks to the tops of the door.
-
Attach the doors to the rails making sure that the anti-jump disks are engaged to avoid a serious accident.
-
Plumb the door and fastem the metal floor guides to the floor using the screws and anchors provided. The opening will depend on the thickness of your door. The guides are adjustable and will accept any thickness.
-
Adjust the door stops accordingly.
Architectural Products by Outwater assumes no liability for improper installation.
Documents / Resources
| BARN
DOOR HARDWARE SDH-SW6-BLK-NR Hardware Kit for Sliding Single Wood
Door
[pdf] Installation Guide
SDH-SW6-BLK-NR Hardware Kit for Sliding Single Wood Door, SDH-SW6-BLK-NR,
Hardware Kit for Sliding Single Wood Door
---|---