BARN DOOR BROWNSTONE SDH-SW04-SS 304 Grade Stainless Steel Installation Guide

June 8, 2024
BARN DOOR

THE BROWNSTONE
Hardware kit for sliding single wood door.
MODEL No. SDH-SW04-SS
304 Grade Stainless Steel

INSTALLATION MANUAL

BARN DOOR BROWNSTONE SDH SW04 SS 304 Grade Stainless
Steel

TOOLS REQUIRED

BARN DOOR BROWNSTONE SDH SW04 SS 304 Grade Stainless Steel -
fig

  • Plumb Line
  • Pencil
  • Phillips Head Screwdriver
  • 8mm Routing Drill Bit
  • 10mm Drill Bit
  • 5.5mm Drill Bit
  • Level
  • Tape Measure
  • Power Drill

INCLUDED IN KIT

A 78-3/4″ Rail x1
B Door Roller Hardware x2
C End Bracket x2
D Center Bracket x2
E ST4.8×50 Bolt x4
F ST5.5×32 Screw x3
G Floor Anchor x3
H Routed Floor Guide x1
I Door Stop x2
J 4mm/6mm Allen Keys x1

Architectural Products by Outwater assumes no liability for improper installation.

THE BROWNSTONE

BARN DOOR BROWNSTONE SDH SW04 SS 304 Grade Stainless Steel - fig
1

NOTES
Minimum door overlap on guide is 1-15/16″
To obtain maximum weight capacity, all fasteners must be mounted into solid wood studs or wall blocking or mounted to a header board.
Adjustable mounting brackets allow for standard 16″ U.S. stud spacing, or any variation.
Consult a structural engineer if you have questions about what type of wall blocking is required.BARN DOOR BROWNSTONE SDH SW04 SS 304 Grade Stainless
Steel - fig3BARN DOOR
BROWNSTONE SDH SW04 SS 304 Grade Stainless Steel - fig 2

Find the centerline of the track. Using a level, mark a horizontal line twice the door width long. Mark the bracket screw locations into the wall blocking. Attach the wall portion of the brackets as shown.BARN DOOR BROWNSTONE SDH
SW04 SS 304 Grade Stainless Steel - fig4

Attach the track to the wall brackets as shown.
Architectural Products by Outwater assumes no liability for improper installation.BARN DOOR BROWNSTONE SDH SW04 SS 304 Grade Stainless Steel -
fig5

  1. Remove the anti-rise pin from the door roller using the provided 4mm Allen key. The bottom of the doors should be routed at this time in order to accept the floor guide.
  2. Drill holes centered in the door thickness for the door roller anchors using an 8mm routing drill bit.BARN DOOR BROWNSTONE SDH SW04 SS 304 Grade Stainless Steel - fig6Attach the door to the rail.Plumb the door and mark the positions of the floor guides. Mount the floor guides to the floor.BARN DOOR BROWNSTONE SDH SW04 SS 304 Grade Stainless Steel - fig7Adjust the door stops accordingly. Tighten the set screw with sufficient force to drive the set screw into the bar after making the final adjustment.
    Reattach the anti-rise pin to the door rollers

Architectural Products by Outwater assumes no liability for improper installation.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals