BARN DOOR HARDWARE SDH-SW4-BLK-8 Hardware Kit for Sliding Single Wood Door Installation Guide

June 8, 2024
BARN DOOR HARDWARE

BARN DOOR HARDWARE SDH-SW4-BLK-8 Hardware Kit for Sliding Single Wood

Door

Hardware kit for sliding single wood door

MODEL No. SDH-SW4-BLK-8

INSTALLATION MANUAL

TOOLS REQUIRED

  • Plumb Line
  • Pencil
  • Phillips Head Screwdriver
  • 8mm Drill Bit
  • 10mm Routing Drill Bit
  • Wrench
  • Level
  • Tape Measure
  • Power Drill

INCLUDED IN KIT

A Door Roller Hardware x2
B 96″ Rail x1
C Wall Bracket x6
D 2.5mm Allen Key x1
E Door Stop x2
F Anti-Jump Disk x2
G Routed Floor Guide x1
H Floor Anchor x2
I ST4.2×25 Screw x2
J M8x30 Wall Anchor x6
K M8x60 Bolt + Washer x6
L M8x90 Bolt x6

Architectural Products by Outwater assumes no liability for improper installation.

CLASSIC STRAP

BARN-DOOR-HARDWARE-Hardware-Kit-for-Sliding-Singl- Woo- Door-
fig-4

NOTES

  • Minimum door overlap on guide is 4-3/4″
    To obtain maximum weight capacity, all fasteners must be mounted into solid wood studs or wall blocking or mounted to a header board.

  • Consult a structural engineer if you have questions about what type of wall blocking is required.

BARN-DOOR-HARDWARE-Hardware-Kit-for-Sliding-Singl- Woo- Door-
fig-5

  1. Find the centerline of the track. Using a level, mark a horizontal line twice the door width long. Mark the bracket screw locations into the wall blocking. Attach the wall portion of the brackets as shown.
  2. Attach the rail to the wall brackets using a wrench to fasten the bolts as shown.BARN-DOOR-HARDWARE-Hardware-Kit-for-Sliding-Singl- Woo- Door-fig-6
  3. Drill out holes in the door using a 10mm routing drill bit as pictured. The bottom of the door should be routed at this time in order to accept the floor guide.
  4. Attach the anti-jump disks to the tops of the door.BARN-DOOR-HARDWARE-Hardware-Kit-for-Sliding-Singl- Woo- Door-fig-7
  5. Attach the doors to the rails making sure that the anti-jump disks are engaged to avoid a serious accident.
  6. Plumb the door and mark the positions of the floor guides. Mount the floor guides to the floor.BARN-DOOR-HARDWARE-Hardware-Kit-for-Sliding-Singl- Woo- Door-fig-8
  7. Adjust the door stops accordingly using the provided 2.5mm Allen key.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals