BARN DOOR SDH-SW4 Classic Strap Installation Guide
- June 8, 2024
- BARN DOOR
Table of Contents
BARN DOOR SDH-SW4 Classic Strap
TOOLS REQUIRED
- Plumb Line
- Pencil
- Phillips Head Screwdriver
- 8mm Drill Bit
- 10mm Routing Drill Bit
- Wrench
- Level
- Tape Measure
- Power Drill
INCLUDED IN KIT
A
| Door Roller Hardware| x2
---|---|---
B
| 78″ Rail| x1
C
| Wall Bracket| x5
D
| 2.5mm Allen Key| x1
E
| Door Stop| x2
F
| Anti-Jump Disk| x2
G
| Routed Floor Guide| x1
H
| Floor Anchor| x2
I
| ST4.2×25 Screw| x2
J
| M8x30 Wall Anchor| x5
K
| M8x60 Bolt + Washer| x5
L
| M8x90 Bolt| x5
DIMENSION
NOTES
Minimum door overlap on guide is 4-3/4″
To obtain maximum weight capacity, all fasteners must be mounted into solid wood studs or wall blocking or mounted to a header board.
Consult a structural engineer if you have questions about what type of wall blocking is required.
INSTALLATION INSTRUCTIONS
-
Find the centerline of the track. Using a level, mark a horizontal line twice the door width long. Mark the bracket screw locations into the wall blocking. Attach the wall portion of the brackets as shown.
-
Attach the rail to the wall brackets using a wrench to fasten the bolts as shown.
-
Drill out holes in the door using a 10mm routing drill bit as pictured. The bottom of the door should be routed at this time in order to accept the floor guide.
-
Attach the anti-jump disks to the tops of the door
-
Attach the doors to the rails making sure that the anti-jump disks are engaged to avoid a serious accident.
-
Plumb the door and mark the positions of the floor guides. Mount the floor guides to the floor.
-
Adjust the door stops accordingly using the provided 2.5mm Allen key.
Architectural Products by Outwater assumes no liability for improper installation.
Documents / Resources
| BARN
DOOR SDH-SW4 Classic
Strap
[pdf] Installation Guide
SDH-SW4 Classic Strap, SDH-SW4, SDH-SW4 Strap, Classic Strap, Strap
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>