BARN DOOR SDH-SG02-SS Skyline 304 Grade Stainless Steel Installation Guide
- June 8, 2024
- BARN DOOR
Table of Contents
THE SKYLINE
Hardware kit for sliding single glass door.
304 Grade Stainless Steel
MODEL No.
SDH-SG02-SS
INSTALLATION MANUAL
TOOLS REQUIRED
• Plumb Line
• Pencil
• Phillips Head Screwdriver
• 8mm Drill Bit| • 5.5mm Drill Bit
• Level
• Tape Measure
• Power Drill
---|---
INCLUDED IN KIT
A | 78-3/4″ Rail | x1 |
---|---|---|
B | Door Roller Hardware | x2 |
C | End Bracket | x2 |
D | Center Bracket | x2 |
E | ST4.8×50 Bolt | x4 |
F | Floor Guide | x1 |
G | Floor Anchor | x2 |
H | ST4.8×32 Screw | x2 |
I | Door Stops | x2 |
J | Adjustable Installation Wrench | x1 |
K | 4mm/8mm Allen Keys | x1 |
THE SKYLINE
NOTES
- To obtain maximum weight capacity, all fasteners must be mounted into solid wood studs or wall blocking or mounted to a header board.
- Adjustable mounting brackets allow for standard 16″ U.S. stud spacing, or any variation.
Find the centerline of the track. Using a level, mark a horizontal line twice the door width long. Mark the bracket screw locations into the wall blocking.
Attach the wall portion of the brackets as shown.
Consult a structural engineer if you have questions about what type of wall blocking is required.
|
---|---
Suggested wall bracket spacing.
Brackets must be secured into wall blocking.| Attach rail to wall as shown.
Remove the anti-rise pin and drill holes centered in door thickness. Mount the
rolling straps to the door.
Position the doors on the rail.
Plumb the door and mark the positions of the floor guides.
Mount the floor guides to the floor.
Adjust the door stops accordingly. Tighten the set screw with sufficient force
to drive the set screw into the bar after making the final adjustment.
Reattach the anti-rise pin to the door rollers
Architectural Products by Outwater assumes no liability for improper installation.