milwaukee 58-22-2012d1 Rechargeable Magnetic Headlamp and Task Light Instruction Manual

: May 21, 2024
: Milwaukee

Table of Contents

IMPORTANT SAFETY INSTRUCTIONS
SPECIFICATIONS
BATTERY
RECHARGEABLE MAGNETIC HEADLAMP
LIMITED WARRANTY – USA & CANADA
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

58-22-2012d1
RECHARGEABLE MAGNETIC HEADLAMP AND TASK LIGHT
Instruction Manual

IMPORTANT SAFETY INSTRUCTIONS

WARNING
READ ALL SAFETY WARNINGS, INSTRUCTIONS, ILLUSTRATIONS AND SPECIFICATIONS PROVIDED WITH THIS POWER TOOL. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. SAVE THESE INSTRUCTIONS- THIS OPERATOR’S MANUAL CONTAINS IMPORTANT SAFETY AND OPERATING INSTRUCTIONS.

AVOID DANGEROUS ENVIRONMENTS. Do not charge battery in rain, snow, damp or wet locations. Do not use battery or charger in the presence of explosive atmospheres (gaseous fumes, dust or flammable materials) because sparks may be generated when inserting or removing battery, possibly causing fire.
CHARGE IN A WELL VENTILATED AREA. Do not block charger vents. Keep them clear to allow proper ventilation. Do not allow smoking or open flames near a charging battery. Vented gases may explode.
MAINTAIN CORD. When unplugging charger, pull plug rather than cord to reduce the risk of damage to the electrical plug and cord. Never carry charger by its cord. Keep cord from heat, oil and sharp edges. Make sure cord will not be stepped on, tripped over or subjected to damage or stress. Do not use charger with damaged cord or plug. Have a damaged charger replaced immediately.
USE ONLY RECOMMENDED ATTACHMENTS. Use of an attachment not recommended or sold by the battery charger or battery manufacturer may result in a risk of fire, electric shock or personal injury.
TO REDUCE THE RISK OF ELECTRIC SHOCK , always unplug charger before cleaning or maintenance.
DO NOT BURN OR INCINERATE BATTERY PACKS. Battery may explode, causing personal injury or damage. Toxic fumes and materials are created when battery are burned.
DO NOT CRUSH, DROP, OR DAMAGE BATTERY. Do not use a battery or charger that has received a sharp blow, been dropped, run over, or damaged in any way (e.g., pierced with a nail, hit with a hammer, stepped on).
DO NOT DISASSEMBLE. Incorrect reassembly may result in the risk of electric shock, fire or exposure to battery chemicals. If it is damaged, take it to a MILWAUKEE service facility.
BATTERY CHEMICALS CAUSE SERIOUS BURNS. Never allow contact with skin, eyes, or mouth. If a damaged battery leaks battery chemicals, use rubber or neoprene gloves to dispose of it. If skin is exposed to battery fluids, wash with soap and water and rinse with vinegar. If eyes are exposed to battery chemicals, immediately flush with water for 20 minutes and seek medical attention. Remove and dispose of contaminated clothing.
DO NOT SHORT CIRCUIT. Do not allow fluids to flow into tool. Corrosive or conductive fluids, such as seawater, certain industrial chemicals, and bleach or bleach containing products, etc., can cause a short circuit. A short circuited battery pack may cause fire, personal injury, and product damage.
STORE in a cool, dry place. Do not store battery where temperatures may exceed 120°F (50°C) such as in direct sunlight, a vehicle or metal building during the summer.
TO REDUCE THE RISK OF INJURY, CLOSE SUPERVISION IS NECESSARY when an appliance is used near children.
STORE IDLE LIGHT OUT OF REACH OF CHILDREN. Warm lights can become hazardous in the hands of children.
KNOW YOUR LIGHT. Read this manual carefully to learn your light’s applications and limitations as well as potential hazards associated with this type of light.
MAINTAIN LABELS AND NAMEPLATES. These carry important information. If unreadable or missing, contact a MILWAUKEE service facility for a free replacement.

SPECIFICATIONS

Cat. No. ………………………………….2012R
USB Input Volts ……………………………. 5 DC
USB Input Amps ………………………………. 0.5 A
Charging Temperature………………….32°F-122°F (0°C to 50°C)
Operating Temperature…………………………-4°F – 122°F (-20°C-50°C)
Power Supply Cat. No. ………………. 44-66-1202

SYMBOLOGY

| Read Operator’s Manual| | Magnet
---|---|---|---
| Do not stare at the operating light source.| | USB
****| European Conformity Mark| | Power

BATTERY

WARNING
To reduce the risk of fire, personal injury, and product damage due to a short circuit, never immerse your product or allow a fluid to flow inside them. Corrosive or conductive fluids, such as seawater, certain industrial chemicals, and bleach or bleach containing products, etc., can cause a short circuit.
Maintenance and Storage
Do not expose your product to water or rain, or allow them to get wet.
This could damage the tool. Do not use oil or solvents to clean or lubricate your tool. The plastic casing will become brittle and crack, causing a risk of injury.
Store product at room temperature away from moisture. Do not store in damp locations where corrosion of terminals may occur. Permanent capacity loss can result if the product is stored for long periods of time at high temperatures (over 120° F). After about a year of storage, charge the product as normal.
WARNING
To reduce the risk of injury or explosion, never burn or incinerate a tool even if it is damaged, dead or completely discharged. When burned, toxic fumes and materials are created.
Disposing of MILWAUKEE Li-Ion Battery
MILWAUKEE Li-Ion batteries are more environmentally friendly than some other types of power tool batteries. Always dispose of your battery according to federal, state and local regulations. Contact a recycling agency in your area for recycling locations. Even discharged batteries contain some energy.
RBRC Battery Recycling Seals
The RBRC™ Battery Recycling Seals (see “Symbology”) on your batteries indicate that MILWAUKEE has arranged for the recycling of that battery with the Rechargeable Battery Recycling Corporation (RBRC). At the end of your battery’s useful life, return the battery to a MILWAUKEE Branch Office/Service Center or the participating retailer nearest you. For more information, visit the RBRC web site at www.rbrc.org.

RECHARGEABLE MAGNETIC HEADLAMP

Charging the Battery

Plug your USB cable into a power source such as an AC wall adaptor, computer or car port.
Lift the rubber cover to expose the micro USB port. Insert the micro USB plug into the micro USB port. Users may experience longer charge times from laptops and other power sources.
The indicator light will display the charging status: Red Flashing: Charging, 0-49% Charged
Yellow Flashing: Charging, 50-99% Charged
Green Solid: 100% Charged
Red Solid: Hot Battery
Red/Green Flashing: Cold, Wet, or Faulty

If the light continues to flash red and green, the battery may be cold, wet, faulty, or the battery did not fully charge after 12 hours. If the light is solid red, the battery is too hot. Allow the battery to cool down, warm up, or dry out. Turn the light on or plug in for charging. If the problem persists, contact a MILWAUKEE service facility.

Operation
CAUTION
To reduce the risk of injury, do not look directly into the light when the light is on.
Connect the light onto the strap and use the buckle to adjust the strap to the required size. Use the included clips to attach to a hard hat. Rotate the light up or down as needed.
Press the power button to turn the light on and off.
Press the mode button to cycle through the light intensities.
The battery indicator light will display the battery capacity for 3 seconds as the light is being turned on or off.
Green Solid: 50-100% remaining
Yellow Solid: 10-49% remaining
Red Solid: 3-9% remaining
During use, when the battery charge reaches 3%, the main LED and charge indicator will flash, indicating up to 5 minutes of runtime remains.
Prior to immediate shutdown, the main LED will flash 3 times, then the tool will shutdown. Remaining runtime may be less than 5 minutes if the light is turned on when battery capacity is already 0-3%.
Undertemperature condition:
If the battery is above 50% charged, the light will turn on at 100lm and stay at 100lm until low battery conditions.
If the battery is below 50% charged, the light will turn at 15lm and stay at 15lm while in use.
Overtemperature condition:
The light will enter a lower output to reduce flashlight temperature.
Once the light has returned to operating temperatures, the light will resume normal operation.
WARNING
To reduce the risk of injury, always unplug product and remove from the charger before performing any maintenance. Never disassemble the tool, battery pack or charger.
Contact a MILWAUKEE service facility for ALL repairs.
Maintaining Tool
Keep the tool, battery pack and charger in good repair by adopting a regular maintenance program. Return the tool, battery pack, and charger to a MILWAUKEE service facility for repair.
Cleaning
Clean dust and debris from vents. Keep handles clean, dry and free of oil or grease. Use only mild soap and a damp cloth to clean, since certain cleaning agents and solvents are harmful to plastics and other insulated parts. Some of these include gasoline, turpentine, lacquer thinner, paint thinner, chlorinated cleaning solvents, ammonia and household detergents containing ammonia. Never use flammable or combustible solvents around tools.

SERVICE – UNITED STATES

1-800-SAWDUST (1.800.729.3878)
Monday-Friday, 7:00 AM – 6:30 PM CST
or visit www.milwaukeetool.com
Contact Corporate After Sales Service Technical Support with technical, service/repair, or warranty questions.
Email: metproductsupport@milwaukeetool.com
Become a Heavy Duty Club Member at www.milwaukeetool.com to receive important notifications regarding your tool purchases.
SERVICE – CANADA
Milwaukee Tool (Canada) Ltd
1.800.268.4015
Monday-Friday, 7:00 AM – 4:30 PM CST or visit www.milwaukeetool.ca

LIMITED WARRANTY – USA & CANADA

(A) 2010R MILWAUKEE Rechargeable 250L Penlight w/ Laser, 2011R MILWAUKEE Rechargeable 500L Everyday Carry Flashlight w/ Magnet, and 2012R MILWAUKEE Rechargeable Magnetic Headlamp and Task Light
2 YEAR LIMITED WARRANTY – The Rechargeable Personal Lighting Products referenced above are warranted to the original purchaser only to be free from defects in material and workmanship. Subject to certain exceptions, MILWAUKEE will repair or replace any part on the above Rechargeable Personal Lighting Products which, after examination, is determined by MILWAUKEE to be defective in material or workmanship for a period of two (2) years after the date of purchase.
(B)All other MILWAUKEE Personal Lighting Products LIMITED LIFETIME WARRANTY – All other MILWAUKEE Personal Lighting Products (see exceptions below) are warranted to the original purchaser only to be free from defects in material and workmanship. Subject to certain exceptions, MILWAUKEE will repair or replace any part on a personal lighting product which, after examination, is determined by MILWAUKEE to be defective in material or workmanship for the lifetime of such personal lighting products.
Normal Wear: This warranty does not cover repair or replacement when normal use has exhausted the life of a part including, but not limited to clips, straps, charging cables, wall plugs, and rubber gaskets. This warranty does cover the LED in the personal lighting products, subject to the limitations herein.
This warranty does not cover Cordless Battery Packs or Chargers. There are separate and distinct warranties available for these products.
Return of personal lighting products to a MILWAUKEE factory Service Center location or MILWAUKEE Authorized Service Station, freight prepaid and insured, is required. A copy of the proof of purchase should be included with the return product. The above warranties do not apply to damage that MILWAUKEE determines to be from repairs made or attempted by anyone other than MILWAUKEE authorized personnel, misuse, alterations, abuse, normal wear and tear, lack of maintenance, accidents, or caused by alkaline batteries.
ACCEPTANCE OF THE EXCLUSIVE REPAIR AND REPLACEMENT REMEDIES DESCRIBED HEREIN IS A CONDITION OF THE CONTRACT FOR THE PURCHASE OF EVERY MILWAUKEE PRODUCT. IF YOU DO NOT AGREE TO THIS CONDITION, YOU SHOULD NOT PURCHASE THE PRODUCT. IN NO EVENT SHALL MILWAUKEE BE LIABLE FOR ANY INCIDENTAL, SPECIAL, CONSEQUENTIAL OR PUNITIVE DAMAGES, OR FOR ANY COSTS, ATTORNEY FEES, EXPENSES, LOSSES OR DELAYS ALLEGED TO BE AS A CONSEQUENCE OF ANY DAMAGE TO, FAILURE OF, OR DEFECT IN ANY PRODUCT INCLUDING, BUT NOT LIMITED TO, ANY CLAIMS FOR LOSS OF PROFITS. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU.
THE ABOVE WARRANTIES ARE EXCLUSIVE AND IN LIEU OF ALL OTHER EXPRESS WARRANTIES, WRITTEN OR ORAL. TO THE EXTENT PERMITTED BY LAW, MILWAUKEE DISCLAIMS ANY IMPLIED WARRANTIES, INCLUDING WITHOUT LIMITATION ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR USE OR PURPOSE; TO THE EXTENT SUCH DISCLAIMER IS NOT PERMITTED BY LAW, SUCH IMPLIED WARRANTIES ARE LIMITED TO THE DURATION OF THE APPLICABLE EXPRESS WARRANTIES AS DESCRIBED ABOVE. SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU, WARRANTYTHESE WARRANTIES GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE.
These warranties apply to product sold in the U.S.A. and Canada only. Please consult the Find a Service Center Search in the Parts & Service section of MILWAUKEE’s website www.milwaukeetool.com or call 1.800.SAWDUST (1.800.729.3878) to locate your nearest MILWAUKEE factory Service Center location.

MILWAUKEE TOOL
13135 West Lisbon Road
Brookfield, Wisconsin, U.S.A. 53005
01611017101Q-01(A) Printed in China