Xhorse XSCD Universal Remote Key User Manual
- June 1, 2024
- Xhorse
Table of Contents
XSCD Universal Remote Key
User Manual
Overview:
XSCD Universal Remote Key is suitable for vehicle which contains the Xhorse
receiver.
Note: The operating temperature of the product is -20–50℃.
Button description:
| Item | Description |
|---|---|
| 1 | Lock button |
| 2 | Unlock button |
| 3 | Start engine button |
| 4 | Trunk button |
| 5 | Panic button |
Change battery:
First use or when the battery runs out need to change new battery, following steps:
Press the back side button for loose the mechanical key holder| Use the tool
into the gap to separate the shell| Take the battery out and replace
new one| Install the key same as before
Note: The battery type is 2032 with 3V, ensure the positive and negative of battery is correct.
Pairing method:
Pairing with vehicle: Referring to the corresponding vehicle models to match.
FCC statements:
§ 15.19 Labelling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
§ 15.21 Information to user.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
§ 15.105 Information to the user.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
*RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
CE & UKCA statements:
Frequency Band(s)
This device operates with the following frequency bands and maximum frequency
power.
Note: The product is compliant with these power limits required by the
European Union. Frequency bands supported by the product vary by model.
RFID (433.92 MHz) Max Pe.r.p. is -18.4 dBm.
EU & UKCA DECLARATION OF CONFORMITY
Hereby, Shenzhen Xhorse Electronics Co., Ltd. declare that Universal Remote Key with model XSCD is in compliance with Directive 2014/53/EU, 2011/65/EU and RER 2017 (SI2017/1206).
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>