Xhorse XKKF Universal Remote Key User Manual
- June 1, 2024
- Xhorse
Table of Contents
Xhorse XKKF Universal Remote Key
Product Specifications:
- Model: XKKF Universal Remote Key
- Suitable for vehicles with Xhorse receiver
- Battery Type: 2032, 3V
- Frequency Band: RFID (433.92 MHz)
- CE & UKCA Compliant
Product Usage Instructions
Button Descriptions:
- 1 – Switch button for mechanical key
- 2 – Panic button of car
- 3 – Lock button of car
- 4 – Unlock button of car
- 5 – Trunk button of car
Changing the Battery:
- Break open the back side plastic cover to access the remote.
- Take out the old battery and replace it with a new 2032 3V battery.
- Ensure the positive and negative terminals of the battery are correctly aligned.
Pairing with Vehicle:
- Refer to the corresponding vehicle models for pairing instructions.
- Install the key back in its place as before.
FCC Statements:
Reorient or relocate the receiving antenna. Increase the separation between
the equipment and receiver. Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected. Consult the dealer or
an experienced radio/TV technician for help.
RF Warning for Portable Device:
The device meets general RF exposure requirements and can be used in
portable exposure conditions without restrictions.
CE & UKCA Statements:
This device complies with European Union power limits and operates at RFID
(433.92 MHz) with a maximum power of -39.48 dBm.
Frequently Asked Questions (FAQ):
-
Q: What battery type does the XKKF Universal Remote Key use?
A: The remote key uses a 2032 3V battery. -
Q: How do I pair the remote key with my vehicle?
A: Refer to the corresponding vehicle models for specific pairing instructions and make sure to install the key back properly after pairing. -
Q: Is the device compliant with CE & UKCA standards?
A: Yes, the device is compliant with CE & UKCA standards and operates within the specified frequency bands and power limits.
XKKF Universal Remote Key User Manual
Overview
XKKF Universal Remote Key is suitable for vehicle which contains the Xhorse receiver. Note: The operating temperature of the product is -20–50℃.
Button description
Item Description
| 1 | Switch button for mechanical key |
|---|---|
| 2 | Panic button of car |
| 3 | Lock button of car |
| 4 | Unlock button of car |
| 5 | Trunk button of car |
Change battery:
First use or when the battery runs out need to change new battery, following
steps:
-
Break open the back side plastic cover to open the remote
-
Take the battery out and replace new one
Note: The battery type is 2032 with 3V, ensure the positive and negative of battery is correct. -
Install the key same as before
Pairing method:
Pairing with vehicle: Referring to the corresponding vehicle models to match.
FCC statements
Labelling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Information to user.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Information to the user.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
- If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
*RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
CE & UKCA statements:
- Frequency Band(s)
- This device operates with the following frequency bands and maximum frequency power.
- Note: The product is compliant with these power limits required by the European Union. Frequency bands supported by the product vary by model.
- RFID (433.92 MHz) Max Pe.r.p. is -39.48 dBm.
EU & UKCA DECLARATION OF CONFORMITY
Hereby, Shenzhen Xhorse Electronics Co., Ltd. declare that Universal Remote Key with model XKKF is in compliance with Directive 2014/53/EU, 2011/65/EU and RER 2017 (SI2017/1206).
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>