Xhorse XKLK Universal Remote Key User Manual
- June 1, 2024
- Xhorse
Table of Contents
Xhorse XKLK Universal Remote Key
Specifications:
- Model: XKLK Universal Remote Key
- Battery Type: CR2032 3V
- Frequency Band: RFID 433.92 MHz
- Max Power: -43.47 dBm
Product Usage Instructions
Button Description
- 1: Switch button for mechanical key
- 2: Lock button of car
- 3: Trunk button of car
- 4: Unlock button of car
Changing the Battery:
- Break open the back side plastic cover to access the remote.
- Remove the old battery and replace it with a new CR2032 3V battery.
- Ensure correct placement of the positive and negative terminals of the new battery.
Pairing with Vehicle:
- Refer to the corresponding vehicle models for pairing instructions.
- Install the key back into the remote as before.
FAQ
Q: What type of battery does the Universal Remote Key use?
A: The Universal Remote Key uses a CR2032 3V battery.
Q: How do I pair the Universal Remote Key with my vehicle?
A: Please refer to the corresponding vehicle models for specific pairing instructions.
Overview
XKLK Universal Remote Key is suitable for vehicle which contains the Xhorse receiver. Note: The operating temperature of the product is -20–50℃.
Button description
Change battery
First use or when the battery runs out need to change new battery, following steps:
-
Break open the back side plastic cover to open the remote
-
Take the battery out and replace new one
Note: The battery type is 2032 with 3V, ensure the positive and negative of battery is correct. -
Install the key same as before
Pairing method
Pairing with vehicle: Referring to the corresponding vehicle models to match.
Fcc statements
Labelling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Information to user.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Information to the user.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
CE & UKCA statements:
Frequency Band(s)
This device operates with the following frequency bands and maximum frequency
power.
Note: The product is compliant with these power limits required by the
European Union. Frequency bands support-ed by the product vary by model.
RFID (433.92 MHz) Max Pe.r.p. is -43.47 dBm.
EU & UKCA DECLARATION OF CONFORMITY
Hereby, Shenzhen Xhorse Electronics Co., Ltd. declare that Universal Remote Key with model XKLK is in compli-ance with Directive 2014/53/EU, 2011/65/EU and RER 2017 (SI2017/1206).