Yaesu M-70D Base Desktop Microphone Instruction Manual

Table of Contents

Yaesu-M-70D-Base-Desktop-Microphon- PRODUCT

This is a one touch PTT key with a lock function.
When the LOCK key is pressed, the transmit mode is set and held, When the key is pressed again the transceiver returns to receive mode again.

PTT key

The angle of the microphone may be adjusted by loosening (turn counterclockwise) the screws on the left and right side of the pivot top. Place the microphone in the desired position and then tighten the screws (turn them clockwise) to secure the microphone.

MIC Jack (8-pin)

Use the supplied microphone cable to connect the microphone to a transceiver that has a “modular terminal”.

MIC Jack (modular)

Use the supplied microphone cable to connect the microphone to a transceiver that has an “8-pin terminal”.

Low-Cut switch

When this switch is ON, a low-cut filter (cut-off frequency 340 Hz, -6 dB/octave) is activated.

Supply Voltage: DC 5.0 V ‡10 % Current Consumption: 15 mA (TYP)
Microphone Type: Condenser microphone
Frequency Response: 30 – 17000 Hz
Sensitivity: -60 dB (1 kHz 0 dB=1V/Pa) Microphone
Impedance: 600 Ohms
Dimensions (W x H x D): 4.2″ x 6.7″ x 5.0″ (106 × 170 x 126.5 mm) *H: Maximum with microphone flat
Weight (approx.): 15.87 oz. (450 g) w/o cable

Using the M-70 with Yasi Transceivers

Requires Optional “Power Supply Kit”. as of Feb, 2021

Thing two complies t) This doe may no Cause Amal deterrence, and 12) this device must accept any interference received, including interference that may
YAESU MUSEN CO., LTD. Tokyo 140-0002 Japan YAESU USA 6125
Phyllis Drive, Cypress, CA 90630, U.S.A. YAESU UK Unit 12, Sun Valley
Business Park, Wynell Close Winchester, Hampshire, S023 OLB, U.K.

caucansonesies operating Manual of the compatible transceiver to use this product safely.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

Disposal of Electrical and Electronic

Equipment Products with the symbol (crossed out wheeled bin) cannot be disposed of as house hold waste.
Electronic and Electrical Equipment should be recycled at a facility capable of handling these items and their waste by products.
Please contact a local equipment supplier representative or service center for information shanty the martellastencustanh war counting