denver VPL-150BT MP3 Playback Built-In Amplifier and Speakers Instruction Manual
- June 13, 2024
- Denver
Table of Contents
Instruction Manual
VPL-150BT
VPL-150BT MP3 Playback Built-In Amplifier and Speakers
www.denver-electronics.com
IMPORTANT SAFETY INSTRUCTIONS
READ CAREFULLY AND KEEP FOR FUTURE REFERENCE
DESCRIPTION
- Lock catch
- Dust cover
- 45rpm adaptor.
- Auto stop control
- Speed selection – Three speed for choice: 33, 45, 78 rpm.
- Carrying handle
- Detachable leg
- Mode selection (Change between Bluetooth and USB/SD).
- Next music
- Play/Pause
- Previous music
- Aux – In
- Line out R channel
- Line out L channel
- DC power jack
INITIAL SET-UP
AMPLIFIER CONNECTION (if required)
Whilst you can listen to your new turntable using the built in speakers you
may wish to connect it to your existing Hi Fi system. Connect the audio plugs
to the Line input on your mixer or amplifier using an RCA cable (not supplied)
- Red plug into R channel input.
- White plug into L channel input.
Playing a record
- Place the record of your choice on the turntable. If required, do not forget to place the adaptor on the record spindle.
- Choose the desired playing speed using the speed selection switch between 33, 45 and 78rpm.
- Turn on the Rotary Power Switch, note that this also controls volume.
- Release the tone arm lock.
- Raise the tone arm with your hand lightly.
- Place the pickup vertically over the desired track of the record, the turntable will start turning automatically.
- Put down the pickup slowly on to the record to play.
- When a record comes to the end. Lift up the tone arm and put it on the rest when finished.
- Replace the protective cap on the stylus and close the tone arm lock.
Playing USB/5D
– Insert the USB drive or SD card
– Press Mode to music mode
– It will play automatically
Bluetooth connection
– Press Mode button to Bluetooth mode. You will hear BEEP BEEP sound and
Bluetooth mode is active.
– Search VPL-150BT by your bluetooth device and connect.
– When connected successfully you can play your music.
ALL RIGHTS RESERVED, COPYRIGHT DENVER ELECTRONICS NS
Electric and electronic equipment and included batteries contains materials,
components and substances that can be hazardous to your health and the
environment, if the waste material (discarded electric and electronic
equipment and batteries) is not handled correctly.
Electric and electronic equipment and batteries is marked with the crossed out
trash can symbol, seen below. This symbol signifies that electric and
electronic equipment and batteries should not be disposed of with other
household waste, but should be disposed of separately.
As the end user it is important that you submit your used batteries to the
appropriate and designated facility. In this manner you make sure that the
batteries are recycled in accordance with legislature and will not harm the
environment.
All cities have established collection points, where electric and electronic
equipment and batteries can either be submitted free of charge at recycling
stations and other collection sites, or be collected from the households.
Additional information is available at the technical department of your city.
Hereby, Inter Sales A/S declares that the radio equipment type VPL-150BT is in
compliance with Directive 2014/53/EU. The full text of the EU declaration of
conformity is available at the following internet address:
http://www.denver-electronics.com/denver-ypl-1508TI
Operating Frequency Range: 2402MHz 2480MHz
Max Output Power: 2.51W
Imported by:
DENVER ELECTRONICS NS
Omega SA, Soeften
DK-8382 Hinnerup
Denmark
www.facebookcom/denverelectronics
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>