Senso LETO 1 Double Recessed Down Lights Instruction Manual

June 1, 2024
senso

**Senso LETO 1 Double Recessed Down Lights Instruction Manual

Senso LETO 1 Double Recessed Down Lights Instruction
Manual**

Mounting Surface
Please make sure the mounting surface is strong enough to hold at least 0.88lb (0.4kg).

Ceiling Thickness
Ceiling thickness must be between 1/4″ & 1″ (6mm & 25mm). If the thickness of the ceiling is thinner than 1/4″ (6mm), use an #6-32 screw to set fixture in place.

Ceiling Cutout
9.25″ x 4.75″ cutout is required
Overview

Read and follow these instructions before installing or maintaining this product

  • This product is suitable for DRY INDOOR LOCATIONS ONLY
  • Make sure this product is NOT on the same circuit as inductive loads, (e.g. fluorescent bulbs, discharge bulbs, ventilation fans, etc…)
  • Allow air to flow freely around the fixture
  • Do not switch on line voltage until all wiring is complete
  • Incorrect wiring will result in irreparable damage to LED and power supply
  • This product should only be installed by a licensed electrician

Warranty

  • This product must be installed in accordance with all applicable installation codes and ordinance
  • Limited five (5) years warranty
  • Warranty is void in the eventuality of unauthorized modifications and/or improper use

Choose Installation Type

Housing Installation

  1. Install appropriate housing(s) between ceiling joists. Connect the driver to the line voltage and ground to enclosure.
    Housing Installation

  2. Finish ceiling installation. Make sure hole is cut to appropriate size and location.
    Housing Installation

Retrofit & Non Fixed Driver Installation

  1. Ensure wire reaches fixture location.
    Housing Installation

  2. Finish ceiling installation. Make sure hole is cut to appropriate size and location.
    Housing Installation

  3. Connect the driver(s) to the line voltage and ground to enclosure. Push driver into ceiling.

LETO 1 Double

  1. Ensure power is off. Lower quick connect wire from ceiling and connect to fixture until you hear a click.

  2. Push fixture into ceiling.

  3. Tighten screw to secure fixture in place.
    Housing Installation

  4. Retaining arms will extend outward.

  5. Make adjustments to desired angle.
    Housing Installation
    Company Logo

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals