Senso LETO-2 Delivered Lumens Instructions
- June 1, 2024
- senso
Table of Contents
LETO 2
Overview
-
Mounting Surface
Please make sure the mounting surface is strong enough to hold at least 0.88lb (0.4kg). -
Ceiling Thickness
Ceiling thickness must be between 1/4″ & 1″ (6mm & 25mm). If the thickness of the ceiling is thinner than 1/4″ (6mm), use an #6-32 screw to set fixture in place.
Read and follow these instructions before installing or
maintaining this product
- This product is suitable for DRY INDOOR LOCATIONS ONLY
- Make sure this product is NOT on the same circuit as inductive loads, (e.g. fluorescent bulbs, discharge bulbs, ventilation fans, etc…)
- Allow air to flow freely around the fixture
- Do not switch on line voltage until all wiring is complete
- Incorrect wiring will result in irreparable damage to LED and power supply
- This product should only be installed by a licensed electrician
Warranty
- This product must be installed in accordance with all applicable installation codes and ordinance
- Limited five (5) years warranty
- Warranty is void in the eventuality of unauthorized modifications and/or improper use
Choose Installation Type
Housing Installation
- Standard
- Plaster Frame
- IC Housing
Install appropriate housing between ceiling joists. Connect the driver to the line voltage and ground to enclosure.
Finish ceiling installation. Make sure hole is cut to appropriate size and
location.
or
Retrofit & Non Fixed Driver Installation
Ensure wire reaches fixture location.
Finish ceiling installation. Make sure hole is cut to appropriate size and location.
Connect the driver to the line voltage and ground to enclosure. Push driver into ceiling.
Insert the two ends of the springs into the two pre-drilled holes on each side
of the Leto 2.
Once inserted, pull the coiled sections away from each other and place over
the two tabs.
Ensure power is off. Lower quick connect wire from ceiling and connect to
fixture until you hear a click.
Raise the 2 springs upward until they clear the hole in ceiling.
Do not scale this when printing this template.
Rev November 24, 2023 
403-216-7043 |
[email protected]