senso SET Recessed Downlight Instruction Manual
- June 13, 2024
- senso
Table of Contents
SET Recessed Downlight
Instruction Manual
SET Recessed Downlight
Overview
Read and follow these instructions before installing or maintaining this product
- This product is suitable for DRY INDOOR LOCATIONS ONLY
- Make sure this product is NOT on the same circuit as inductive loads, (e.g. fluorescent bulbs, discharge bulbs, ventilation fans, etc…)
- Allow air to flow freely around the fixture
- Do not switch on line voltage until all wiring is complete
- Incorrect wiring will result in irreparable damage to LED and power supply
- This product should only be installed by a licensed electrician
Warranty
- This product must be installed in accordance with all applicable installation codes and ordinance
- Limited five (5) years warranty
- Warranty is void in the eventuality of unauthorized modifications and/or improper use
Drivers and Wiring
On-site installer to provide wire for connection between driver and fixture.
Non-Dimming Driver: 902-35010 (10W)
Constant Current
1-7 Fixtures per driver wired in series.
Remote Driver can be mounted Horizontally or Vertically.
Minimum clearance of 2” (51mm) around the driver is required for proper
air circulation.
Dimming Driver: 902-35025 (25W)
Constant Current
3-17 Fixtures per driver wired in series.
Remote Driver can be mounted Horizontally or Vertically.
Minimum clearance of 2” (51mm) around the driver is required for proper air
circulation.
Cut hole to correct size and in all desired locations.
Finish surface and ensure wiring reaches all locations. Pull wire through hole and make electrical connections.Push fixture into hole. Springs will release once it clears the ceiling.
Do not scale this when printing this template.
MADE IN CANADA
403-216-7043
info@sensolighting.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>