senso LETO 11 and 11.5 Wet Canopy with Hand Straight Solid Stem Instruction Manual
- June 12, 2024
- senso
Table of Contents
senso LETO 11 and 11.5 Wet Canopy with Hand Straight Solid Stem
Product Information
The LETO 11 & 11.5 Wet canopy with hand straight solid stem is a lighting fixture designed for outdoor use. It is made in Canada and is a proud member of Sensolighting’s product lineup. The product comes with a warranty, which may be voided by unauthorized modifications and/or improper use. Please read and follow the instructions provided below before installing or maintaining the product.
Product Usage Instructions
- Begin the installation process by removing the screws from the canopy.
- Slide the canopy down the stem, being careful not to scratch the stem.
- Attach the bracket to the junction box and make the necessary electrical connections.
- Slide the canopy up to the bracket and secure it in place using screws.
- Apply silicone between the ceiling and the canopy, ensuring a proper seal.
- Additionally, apply silicone to seal the hole above the swivel.
For any further assistance or inquiries, please contact Sensolighting at 403-216-7043 or via email at info@sensolighting.com.
Read and follow these instructions before installing or maintaining this product
- This product is suitable for DAMP OR WET LOCATIONS
- Make sure this product is NOT on the same circuit as inductive loads, (e.g. fluorescent bulbs, discharge bulbs, ventilation fans, etc…)
- Allow air to flow freely around the fixture
- Do not switch on line voltage until all wiring is complete
- Incorrect wiring will result in irreparable damage to LED and power supply
- This product should only be installed by a licensed electrician
Warranty
- This product must be installed in accordance with all applicable installation codes and ordinance
- Limited five (5) years warranty
- Warranty is void in the eventuality of unauthorized modifications and/or improper use
Installation
- Remove screws from canopy
- Slide canopy down stem. Be careful not to scratch stem.
- Attach bracket to junction box. Make electrical connection.
- Slide canopy up to bracket and secure in place with screws.
- Apply silicone between ceiling and canopy. Apply silicone to seal the hole above the swivel.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>