senso LETO 5 Track Adapter Instruction Manual

Table of Contents

senso-LETO-5-Track-Adapter-product

Specifications

Installation

Insert the track adapter into the track.
Ensure the adapter tab aligns with the groove in the track to prevent misalignment.
Rotate the locking lever from left to right to secure the adapter in place.
Select the circuit by turning the knob until the number aligns with the arrow:
- 1 Circuit: Align with number 1
- 2 Circuit: Align with number 2
Adjust the fixture to the desired angle.

Note: For Helios, loosen the set screw to adjust and tighten to secure in place.

FAQ

Q: Can I use the Stucchi Track Adapter with other track lighting systems?
A: The Stucchi Track Adapter is designed specifically for use with Leto 5, 11 Mini, 44 Mini, 15, 16, and Helios 1 track lighting systems. It is recommended to use it only with compatible systems for optimal performance.
Q: What should I do if the adapter tab and track groove do not align?
A: If the tab and groove do not align, do not force the adapter into the track. Make sure to realign them properly to ensure a secure fit and prevent any damage to the track or the adapter.

STUCCHI TRACK ADAPTER

FOR LETO 5, 11 MINI, 44 MINI, 15, 16, HELIOS 1

Overview

Read and follow these instructions before installing or maintaining this product

This product is suitable for DRY INDOOR LOCATIONS ONLY
Make sure this product is NOT on the same circuit as inductive loads, (e.g. fluorescent bulbs, discharge bulbs, ventilation fans, etc…)
Allow air to flow freely around the fixture
Do not switch on line voltage until all wiring is complete
Incorrect wiring will result in irreparable damage to LED and power supply
This product should only be installed by a licensed electrician

This product must be installed in accordance with all applicable installation codes and ordinance
Limited five (5) years warranty
Warranty is void in the eventuality of unauthorized modifications and/or improper use

Insert the track adapter into the track.
Make sure the adapter tab matches the groove in the track.
NOTE: The adapter will not fit if the tab and track groove are misaligned
Rotate the locking level from left to right to lock the adapter in place. $senso-LETO-5-Track-Adapter- $1$$
Select the circuit by turning the knob until the number aligns with the arrow.
1. Circuit : Align with number 1
2. Circuit : Align with number 2
Adjust the fixture to the desired angle.
NOTE : For Helios, loosen the set screw to adjust and tighten to secure in place. $senso-LETO-5-Track-Adapter- $2$$