DORMAN H621212 Rear Driver Side Brake Hydraulic Hose Instructions
- June 1, 2024
- DORMAN
Table of Contents
DORMAN H621212 Rear Driver Side Brake Hydraulic Hose
Product Information
Specifications:
- Product Name: Brake Hose Replacement
- Material: Steel brake line with rubber hose
- Compatibility: Various vehicle models (refer to appropriate shop manual)
- Includes: Replacement hose, fittings (if needed)
Product Usage Instructions
Installation Process
- Read the instructions thoroughly before starting the installation work.
- Refer to the specific service procedures for your vehicle in the shop manual.
- If unsure or lack the necessary skills, seek assistance from a qualified technician.
- Pay attention to all cautions and warnings in the shop manual.
- Ensure the replacement hose is designed without a permanent steel line.
- Obtain the correct length of steel brake line and use a line bending tool to make appropriate bends.
- If using a steel line with flared fittings, discard the fitting provided with the hose.
- If fabricating the steel line, use bulk tubing and a double flare tool. The fitting for connecting to the hose is included with the hose.
- Match the style of the end of the hard line attaching to the vehicle’s system with the existing style (inverted double flare or ISO flare).
- This installation procedure should be carried out by an experienced technician.
FAQ
Q: Can I install the brake hose myself without prior experience?
A: It is recommended to seek the services of a qualified technician if you lack the necessary skills or experience to install the brake hose properly.
Q: Do I need special tools for bending the replacement brake line?
A: Yes, you will need a line bending tool to correctly bend the replacement brake line to conform to the original shape.
Q: What should I do if my vehicle’s steel brake line already has fittings?
A: If your steel brake line has flared fittings, you can discard the fitting provided with the replacement hose.
NOTE: READ INSTRUCTIONS THOROUGHLY BEFORE INSTALLATION WORK BEGINS
BRAKE HOSE INSTALLATION INSTRUCTIONS
ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain specific service procedures for this part. If you do not have a service manual or lack the skill to install this part, it is recommended that you seek the services of a qualified technician. Pay special attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.
A steel brake line may be permanently attached to the brake hose on some vehicles (figure 1). This replacement hose is designed without the permanent steel line. You must obtain the correct length of steel brake line and make the appropriate bends (figure 2).
- If the steel brake line being used is already equipped with flared fittings, the fitting provided with this hose can be discarded (figure 3).
- If fabricating the steel line with bulk tubing and a double flare tool, the fitting for the end that will connect to the hose is included with the hose (figure 3).
- The end of the hard line attaching to the vehicle’s system must match the style already on the vehicle (inverted double flare or ISO flare).
This procedure should be performed by an experienced technician
Disclaimer
Even though every attempt to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a qualified auto technician before attempting to perform any work you are not qualified to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
9901003