PYREX SB-450 LUXX Kettle with Tea Instruction Manual

Instructions | Manual

Kettle SB-450 LUXX
www.pyrex.com.gr

SB-450 LUXX Kettle with Tea

Thank you for choosing a product of the new PYREX® electrical appliances range.
We hope that you will be satisfied by the use of this product.
The well-known heat-resistant glass cookware PYREX® has been a part of the Greek households for over 60 years. The range is now further  supplemented with non-stick cookware and electrical appliances.

Please unfold the front page in order to check on the detailed view of the product.

IMPORTANT SAFEGUARDS

• Make sure your electricity supply is the same as the one shown on the under- side of the appliance.

• Always plug your device into an outlet that is earthed. Failure to comply with this requirement may result in electric shock and possible serious  injury.

• Never leave the appliance unattended when it is operating.

• Close supervision is necessary when your appliance is being used near children or infirm people. Ensure that they do not play with the appliance.

• This appliance is not intended for use by people with reduced physical, sensory or mental capabilities, children or those with lack of experience  and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

• Switch off and unplug:
  – After each use.
  – Before cleaning.

• Never use the appliance for any other use than indicated.

• The device is intended for indoor use. Do not use the device outdoors.

• The device is intended only for domestic use. Any other use will cancel the warranty.

• Always use the kettle on a secure, dry, clean and heat resistant surface.

• Do not operate or place the device or parts in places of high humidity or where it may get wet.

• Never let the power unit, cord or plug get wet. If the appliance does get wet, immediately remove the power cord from the wall outlet and do  not put your hands in the water. Never run the wet appliance and contact one of the authorized PYREX-BENRUBI service centers.

• Misuse of your kettle can result in injury.

• Do not let the power cord of the appliance hang over the edge of a table or bench top or touch any hot surface.

• Never leave the power cable wrapped during use. Unwind it completely.

• Never use highly corrosive or abstractive cleaning agents. Never use metal scouring pads for cleaning.

• Always use the water filter and never overfill – boiling water may splash out.

• Avoid contact with steam coming out of the spout area when pouring and out of the lid or spout area when refilling.

• Only use the powerbase supplied and keep it clean and dry.

• Make sure the lid is secure before switching the kettle on.

• Warning: Do not open the lid while the water is boiling

• Be careful when opening the lid – droplets of hot water may be ejected.

• Make sure the kettle is switched off before lifting or pouring.

• Remove the kettle from the base before filling or pouring

• Never put the kettle near or on hot plates or gas burners.

• This kettle is for boiling water only.

• Do not move the appliance when it is in operation.

• Do not touch the appliance with wet or damp hands.

• Do not use an extension power cord.

• Check the power cord periodically for possible damages. If the power cord or the plug of the appliance have been damaged, do not use the  appliance and contact an authorized PYREX-BENRUBI Service Center.

• In case of a possible damage, do not attempt to repair the appliance by yourself. Please contact one of the authorized PYREX-BENRUBI service centers.

• Any repair made by a unauthorized PYREX-BENRUBI Service Center CANCELS THE GUARANTEE.

• Any misuse of the device cancels the warranty.

• Use only original PYREX® spare parts.

• The appliance conforms to EU directive 2014/30/EU on Electromagnetic Compatibility, the 2014/35/EU Low Voltage Directive, the  2011/65/EU RoHS Directive, the directive 2009/125/EC for eco-design and the EC regulation no. 1935/2004 on materials intended to  contact with food.
  SAVE THESE INSTRUCTIONS

PARTS OF THE APPLIANCE

Safety lid
Lid release button “PUSH”
Power button O/I
Handle
Tea/Herbs filter| Base
Spout
Water filter
Light indicator
---|---

BEFORE FIRST USE

• Press the lid release button “PUSH” (2) and fill to “MAX” with cold water without detergent.
• Place the kettle on the base.
• Plug in and press the power button O/I (3).
• Once the boiling process is finished, discard the water and repeat 2 to 3 times.

USE YOUR KETTLE

1. Press the lid release button “PUSH” (2) (fig. 1) and fill the kettle with cold water (fig. 2).
   HINT: Save Energy – Do not boil more water than you need.
   Attention! Make sure the water level does not exceed the MAX indication.

2. Place the kettle on the base (6) (fig. 3).

3. The water will boil and the kettle will switch off automatically (fig.5). The light indicator (8) will turn on.

4. Your kettle will boil and switch off automatically (fig. 5) and the light indicator (8) will turn off 5. Unplug the power cord.
   To interrupt the boiling, ensure that the switch is on the “O” (OFF) position before removing the kettle from the powerbase.
   Your kettle is fitted with a filter to hold back limescale particles.
   If you find drops of water under your kettle, don’t worry – it is just condensation.
   Note: Do not leave water in the kettle after each use.

USE YOUR KETTLE WITH THE TEA/HERBS ACCESSORY

Follow steps 1 – 4 from “use your kettle” section

1. Fill the tea/herbs filter (5) with the quantity of tea or herbs that you desire. Never use tea or herbs packed pods, always use unpacked tea or  herbs.
2. Place the tea/herbs filter (5) on its position into the kettle and leave it into the kettle according to your preference. Always follow the perpetration introductions that the supplier of the tea/herbs recommends.
3. Unplug the power cord.
   Warning! Do not open the lid while the water is boiling.

DESCALING

• Regular descaling of the flat element will improve the performance of your kettle. If the kettle is not descaled regularly the build up of limescale may result in the following:
  – The kettle may take longer to boil.
  – The flat element may be damaged.

Please note: Not descaling your kettle may invalidate your guarantee.
When lime scale starts to build up on the heating element:
– Buy a suitable descaler from a super market and descale your kettle following the instructions mentioned on the descaler packaging.
– After descaling, boil with fresh water several times and discard.
– Clean any descaler off the kettle – it can damage the parts.

• Some regions of the country have chalky water. This makes boiled water look cloudy and leaves deposit on the side of the kettle. This is normal but can be removed with regular cleaning.
• Alternatively, to reduce limescale build up, use filtered water to fill your kettle.

CARE AND CLEANING

• Before cleaning, unplug your kettle and let it cool down.
• The outside and power base: Wipe with a damp cloth, then dry. Never use highly corrosive or abstractive cleaning agents. Never use metal  scouring pads for cleaning.
• The filter: Pull the lid lever (5) and gently take off the filter. Either rinsed under the tap or use a soft brush. Rinse thoroughly. Re-fit to its  position. Close and lock the lid by pressing the lid down.

CAUTION: Never wash the water filter in the dishwasher.

TECHNICAL CHARACTERISTICS

Model: Water kettle SB-450
Voltage: AC 220~240V
Frequency: 50/60Hz
Rated input: 1850W -2200W
Max capacity: 1.8lt

IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EC DIRECTIVE 2002/96/EC

At the end of its working life, the product must not be disposed of as urban waste. It must be taken to a special local authority differentiated waste collection centre or to a dealer providing this service. Disposing of a household appliance separately avoids possible negative consequences on the environment and health deriving from inappropriate disposal and enables the constituent materials to be recovered to obtain significant savings in  energy and resources.
As a reminder of the need to dispose of household appliances separately, the product is marked with a crossed-out wheeled dustbin.

SERVICE AND CUSTOMER CARE

• BENRUBI Company guarantees its products for any manufacturing defect or defective materials for a period of two (2) years from the date of  purchase or delivery by presenting purchase receipt. If your product malfunctions or you find any defects, please revert to the retail location  you have purchased it from or contact an authorized PYREX-BENRUBI Service Centre.
  To find the nearest authorized PYREX-BENRUBI Service Centre, visit our website www.benrubi.gr. It is in the discretion of BENRUBI Company to replace or repair the defective product.

• The warranty does not cover damages resulting from normal wear, breakage, improper installation or maintenance of the product, mishandling, abnormal working conditions, failure to implement the instructions, conversion or repair of the product by an unauthorized technician who  does not belong to the PYREX-BENRUBI Service Centers.

Also, the warranty does not cover the following indicative factors:

• Stains, discoloration or scratches.
• Burns due to exposure to heat or flame.
• Damage from thermal shock (sudden temperature change or change of voltage).

www.pyrex.com.gr

(NEW) H. BENRUBI & FILS SA
27 Aghiou Thoma str, GR15124, Maroussi – Athens
Tel. / Customer Support: 210 6156400, e-mail: [email protected]
Pyrex® is a trademark of Corning Incorporated used under license by International Cookware

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>