DORMAN 919-164 Stainless Steel Brake Line Kit Instructions
- June 1, 2024
- DORMAN
Table of Contents
919-164
TECH NOTES: INSTALLATION
919-164 Stainless Steel Brake Line Kit
ATTENTION: Refer to the appropriate shop manual for your vehicle to
obtain specific service procedures for this part. If you do not have a service
manual or lack the skill to install this part, it is recommended that you seek
the services of a qualified technician. Pay special attention to all cautions
and warnings included in the shop manual. Read and follow all instructions
carefully.
Ford F-150 2000–1997, Ford Lobo 2000
The brake lines in this kit may appear different from original lines on
vehicle. The lines may have slightly different shapes and bends but are
designed to be a direct replacement. Some original lines may use flexible hose
sections near the master cylinder and brake proportioning valve. The
replacement lines in this kit will use solid lines in lieu of metal flexible
hose sections. It is recommended to hand start all fittings into all mating
components before performing final tightening of all fittings.
The replacement brake lines may have additional large radius shipping bends
(Fig. A).
Lines with additional shipping bends will have stickers on either side of each
shipping bend. Carefully straighten the section of line between the stickers
to remove shipping bend (Fig. A). Take care not to kink or damage brake lines.
If a brake line is kinked or damaged while removing shipping bends, it must be
repaired or replaced prior to installation.
Each line will have a tag with a part number; this tag also indicates the
location of line on the truck to help aid in installation.
Inspect all areas of line contact for any possibilities of chafing or rub-
through. Adjust or bend line configuration if needed to avoid areas of rub-
through.
Consult vehicle service manual for brake system bleeding procedure and bleed
hydraulic brake system.
Disclaimer:
Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a qualified auto technician before attempting to perform any work you are not qualified to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
©2020 Dorman Products, Inc.
No reproductions in whole or in part without prior written approval.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>