Aveek B0CN95HCLS Wireless Microphoone Instruction Manual

Aveek B0CN95 HCLS Wireless Microphone

ACCESSORIES

• Handheld Microphone*2
  

• Receiver*l
  

• USB charging cable*l
  

• Mic Cover*2
  

• Anti-slip Ring*2
  

• 1/4 converter*l

SPECIFICATIONS

Frequency Response: 50Hz-15Khz
Operating Range: Up to 60m
Frequency Stability: +0.0005 MHz
SNR: 96dB
Sound Distortion: <0.5%
Mic Input Sensitivity: -51dBV
RF Sensitivity: -95dBm
Operating Temperature: -0 C to +55 C

MICROPHONES STRUCTION

Front

Back

Install 2*AA batteries before using the wireless microphone and installing instruction is as follows:

1. Take down the tail tube of mic.
2. Install the batteries and tighten tail tube of mic.
   Note: The positive and negative polarity of battery cannot be reversed.
   Important: 2*AA batteries not included.
   

RECEIVER INSTRUCTION

1. Battery Compartment
2. Signal Antenna
3. RF Light
4. USB Charging Port
5. Battery Indicator
6. Power Button
   

Receiver working hours Connecting 2 microphones at the same time can work for up to 6 hours.

Receiver battery charging method Use the usb charging cable to connect the receiver inside the type-c interface for charging, it takes 5 hours to be full.

LIGHT INSTRUCTION

RF LightQ)➂| Green light on| The receiver and microphone are connected successfully.
---|---|---
Green light off| The receiver is not connected to the microphone.
Battery
Indicator 5➄| Red light on| The receiver is charging.
Green light on| The receiver is working,
Turns red and flashes quickly| The power of the receiver is in allow battery status.

HOW TO USE

1. Put the 18650 battery into the receiver battery compartment ,turn on the receiver and the green power indicator lights up.
   

2. Connect the receiver to an audio device such as a speaker, Singing Machine, Audio Amplifier, Pa System, Mixer, Voice Amplifier(Note: Only compatible with 6.35mm or 114inch audio devices).
   

3. Open the microphone battery cover and install 2 *AA battery in the indicated positive and negative directions (note: the positive and negative electrodes of the battery cannot be reversed).
   

4. Long press the microphone on/off button to turn on the microphone, and the microphone display screen will light up (if the red indicator light illuminates, it indicates low battery power, and the battery should be replaced in a timely manner).
   

5. The receiver and microphone are automatically paired and the receiver RF blue indicator lights up to start working.

OPERATING ENVIRONMENTS & NOTES

 When using this device, keep it away from water.

 Use the device in ventilated environment, keep it away from fire.

 Since it’s a wireless device, please keep it away from other interfering sources.

 Don’t take apart the device.

 Please use the standard power supply, high voltage may damage the device.

 Please place the used batteries into the recycle bin, don’t litter them.

TROUBLESHOOTING

Change to new batteries.
Microphone screen shows red light| The microphone is in a low power state, please replace the battery in a timely manner.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>